...
首页> 外文期刊>Royal Society Open Science >Enhancement of thermoelectric properties of La-doped SrTiO3 bulk by introducing nanoscale porosity
【24h】

Enhancement of thermoelectric properties of La-doped SrTiO3 bulk by introducing nanoscale porosity

机译:通过引入纳米级孔隙率来增强La掺杂SrTiO3块的热电性能

获取原文

摘要

Electron-doped SrTiO 3 is a well-known n -type thermoelectric material, although the figure of merit of SrTiO 3 is still inferior compared with p -type metal oxide-based thermoelectric materials due to its high lattice thermal conductivity. In this study, we have used a different amount of the non-ionic surfactant F127 during sample preparation to introduce nanoscale porosities into bulk samples of La-doped SrTiO 3 . It has been observed that the porosities introduced into the bulk sample significantly improve the Seebeck coefficient and reduce the thermal conductivity by the charge carrier and phonon scattering respectively. Therefore, there is an overall enhancement in the power factor (PF) followed by a dimensionless figure of merit ( zT ) over a wide scale of temperature. The sample 20 at% La-doped SrTiO 3 with 600 mg of F127 surfactant (SLTO 600F127) shows the maximum PF of 1.14 mW m ?1 K ?2 at 647 K which is 35% higher than the sample without porosity (SLTO 0F127), and the same sample (SLTO 600F127) shows the maximum value of z T is 0.32 at 968 K with an average enhancement of 62% in zT in comparison with the sample without porosity (SLTO 0F127).
机译:电子掺杂的SrTiO 3是公知的n型热电材料,尽管由于其高的晶格热导率,SrTiO 3的品质因数仍低于​​基于p型金属氧化物的热电材料。在这项研究中,我们在样品制备过程中使用了不同量的非离子表面活性剂F127,以将纳米级孔隙率引入La掺杂SrTiO 3的整体样品中。已经观察到,引入到大块样品中的孔隙率分别通过电荷载流子和声子散射显着改善了塞贝克系数并降低了热导率。因此,在整个温度范围内,功率因数(PF)都有整体提高,其后是无因次的品质因数(zT)。具有600 mg F127表面活性剂(SLTO 600F127)的20 at%La掺杂SrTiO 3样品在647 K时显示的最大PF为1.14 mW m?1 K?2,比无孔隙率的样品(SLTO 0F127)高35%。 ,相同的样品(SLTO 600F127)显示在968 K时z T的最大值为0.32,与没有孔隙的样品(SLTO 0F127)相比,zT的平均值提高了62%。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号