首页> 外文期刊>Fresenius environmental bulletin >TiO2, WO3, AND V2O5, SUPPORTED ON ACTIVATED CARBON: PREPARATION, STRUCTURAL AND CATALYTIC BEHAVIOUR IN PHOTOCATALYTIC TREATMENT OF PHENOL AND LIGNIN FROM OLIVE MILL WASTEWATER
【24h】

TiO2, WO3, AND V2O5, SUPPORTED ON ACTIVATED CARBON: PREPARATION, STRUCTURAL AND CATALYTIC BEHAVIOUR IN PHOTOCATALYTIC TREATMENT OF PHENOL AND LIGNIN FROM OLIVE MILL WASTEWATER

机译:活性炭上负载的TiO2,WO3和V2O5:光处理废水中的苯酚和木质素的制备,结构和催化行为

获取原文
           

摘要

The photocatalytic degradation of olive mill wastewater (OMW) of TiO2/V2O5/AC and TiO2/ WO3/AC (activated carbon) catalysts, prepared by a sol-gel method in aqueous solution was investigated. Initially, the TiO2/V2O5/AC and TiO/WO3/AC nanoparticles were obtained using a sufficient thermal treatment by gradually increasing the temperature from 300, 400 and 500°C with 1 h intervals for a total of 3 h. Then, the characterizations of these materials were carried out using (SEM), (TEM), (EDX), (FTIR) and X- (XRD). Secondly; the photocatalytic degradation of these materials has been investigated in OMW using ultraviolet (UV), hydrogen peroxide (H2O2) and nanoparticles. Initially, chemical coagulation experiments with lime and alum have been carried out to obtain more treatment. In the photolytic degradation, the effect of catalysis, times, pH, H2O2 and temperature were selected as parameters. The results show that the removal percentage of color, phenol and lignin increased with the use of H2O2 and O3 together. The percentage removals of color for TiO/W〇3/AC, Ti〇2/V2〇5/AC were 89.55 and 86.30%c respectively. In addition, the percentage removals for phenol were 94.30, 96.26% and for lignin 51.96 and 48.08%, respectively. Optimum values for the degradation of color and phenol were found at pH 7.0 using TiO/WO3/AC, and TiO/V2O5/AC, whereas, the optimum degradation for lignin was achieved when the solution was pH 9.0 for the same nanocomposite materials. The optimum time and temperature were found 24 h at 308K. The pseudofirst order model was applied and R2 values were from 0.90 to 0.99.
机译:研究了溶胶-凝胶法制备的TiO2 / V2O5 / AC和TiO2 / WO3 / AC(活性炭)催化剂对橄榄磨废水的光催化降解。最初,使用足够的热处理,通过以1小时为间隔将温度从300、400和500°C逐渐升高,总共3小时,来获得TiO2 / V2O5 / AC和TiO / WO3 / AC纳米颗粒。然后,使用(SEM),(TEM),(EDX),(FTIR)和X-(XRD)对这些材料进行表征。其次;这些材料的光催化降解已在OMW中使用紫外线(UV),过氧化氢(H2O2)和纳米颗粒进行了研究。最初,已经进行了石灰和明矾的化学混凝实验,以获得更多的处理方法。在光解降解中,选择催化效果,时间,pH,H2O2和温度作为参数。结果表明,同时使用过氧化氢和过氧化氢可去除颜色,酚和木质素。 TiO /W〇3/ AC,Ti〇2/V2〇5/ AC的脱色百分比分别为89.55和86.30%c。另外,苯酚的去除百分率分别为94.30、96.26%和木质素的去除百分率分别为51.96和48.08%。使用TiO / WO3 / AC和TiO / V2O5 / AC在pH 7.0时发现了最佳的颜色和苯酚降解值,而对于相同的纳米复合材料,当溶液的pH值为9.0时,木质素的最佳降解值得以实现。发现最佳时间和温度是308K,24小时。应用伪一阶模型,R2值为0.90至0.99。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号