...
首页> 外文期刊>Frontiers in Microbiology >Sequential parametric optimization of methane production from different sources of forest raw material
【24h】

Sequential parametric optimization of methane production from different sources of forest raw material

机译:从不同森林原料来源的甲烷生产的顺序参数优化

获取原文
           

摘要

The increase in environmental problems and the shortage of fossil fuels have led to the need for action in the development of sustainable and renewable fuels. Methane is produced through anaerobic digestion of organic materials and is a biofuel with very promising characteristics. The success in using methane as a biofuel has resulted in the operation of several commercial-scale plants and the need to exploit novel materials to be used. Forest biomass can serve as an excellent candidate for use as raw material for anaerobic digestion. During this work, both hardwood and softwood species—which are representative of the forests of Sweden—were used for the production of methane. Initially, when untreated forest materials were used for the anaerobic digestion, the yields obtained were very low, even with the addition of enzymes, reaching a maximum of only 40 mL CH_(4)/g VS when birch was used. When hydrothermal pretreatment was applied, the enzymatic digestibility improved up to 6.7 times relative to that without pretreatment, and the yield of methane reached up to 254 mL CH_(4)/g VS. Then the effect of chemical/enzymatic detoxification was examined, where laccase treatment improved the methane yield from the more harshly pretreated materials while it had no effect on the more mildly pretreated material. Finally, addition of cellulolytic enzymes during the digestion improved the methane yields from spruce and pine, whereas for birch separate saccharification was more beneficial. To achieve high yields in spruce 30 filter paper units (FPU)/g was necessary, whereas 15 FPU/g was enough when pine and birch were used. During this work, the highest methane yields obtained from pine and birch were 179.9 mL CH_(4)/g VS and 304.8 mL CH_(4)/g VS, respectively. For mildly and severely pretreated spruce, the methane yields reached 259.4 mL CH_(4)/g VS and 276.3 mL CH_(4)/g VS, respectively. We have shown that forest material can serve as raw material for efficient production of methane. The initially low yields from the untreated materials were significantly improved by the introduction of a hydrothermal pretreatment. Moreover, enzymatic detoxification was beneficial, but mainly for severely pretreated materials. Finally, enzymatic saccharification increased the methane yields even further.
机译:环境问题的增加和化石燃料的短缺导致需要在开发可持续和可再生燃料方面采取行动。甲烷是通过有机材料的厌氧消化而产生的,是具有非常有前途的特性的生物燃料。使用甲烷作为生物燃料的成功导致了一些商业规模的工厂的运转,并需要开发新的待使用材料。森林生物量可以用作厌氧消化的原料。在这项工作中,代表瑞典森林的硬木和软木物种都被用来生产甲烷。最初,当使用未经处理的森林材料进行厌氧消化时,即使添加酶,所获得的产量也非常低,当使用桦木时,最高产量仅为40 mL CH_(4)/ gVS。当进行水热预处理时,酶消化率相对于未经预处理的酶消化率提高了6.7倍,甲烷的产率达到了254 mL CH_(4)/ gVS。然后检查化学/酶解毒的效果,其中漆酶处理提高了较苛刻预处理的物料的甲烷产率,而对较温和预处理的物料没有影响。最后,在消化过程中添加纤维素分解酶可提高云杉和松树的甲烷产率,而桦木单独糖化则更为有益。为了在云杉中获得高产量,必须使用30滤纸单位(FPU)/ g,而使用松木和桦木则需要15 FPU / g。在这项工作中,从松树和桦树中获得的最高甲烷产量分别为179.9 mL CH_(4)/ g VS和304.8 mL CH_(4)/ gVS。对于轻度和重度预处理的云杉,甲烷产量分别达到259.4 mL CH_(4)/ g VS和276.3 mL CH_(4)/ gVS。我们已经证明,森林材料可以用作有效生产甲烷的原材料。引入水热预处理可以显着改善未经处理的材料的最初低收率。此外,酶解毒是有益的,但主要用于经过严格预处理的材料。最后,酶促糖化进一步提高了甲烷的产率。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号