首页> 外文期刊>Analytical Sciences >Selective Extraction of Calcium on Tri-n-butyl Phosphate Plasticized Selective Extraction of Calcium on Tri-n-butyl Phosphate Plasticized Polyurethane Foam for Its Spectrophotometric Determination in Glass and Ceramics
【24h】

Selective Extraction of Calcium on Tri-n-butyl Phosphate Plasticized Selective Extraction of Calcium on Tri-n-butyl Phosphate Plasticized Polyurethane Foam for Its Spectrophotometric Determination in Glass and Ceramics

机译:磷酸三正丁酯增塑的钙的选择性萃取钙的光度法测定玻璃和陶瓷中的磷酸正丁酯增塑的钙的选择性萃取

获取原文
           

摘要

The present paper describes the application of a solid phase extraction system in order to separate traces of calcium from glass and ceramics for its spectrophotometric determination. The method is based on the extraction of calcium from sodium hydroxide solution by tri-n-butyl phosphate (TBP) loaded polyurethane foam (PUF), followed by its elution in hydrochloric acid. The spectrophotometric measurement of the absorbance of calcium complex with calconcarboxylic acid (2-hydroxy-1-(2-hydroxy-4-sulfo-1-naphthylazo)-3-naphthoic acid) takes place at pH 12. The following parameters were studied: effects of sodium hydroxide concentration and temperature on the extraction of calcium, time of equilibration for quantitative calcium extraction, effect of TBP concentration, effect of hydrochloric acid concentration for quantitative elution of calcium from PUF, effect of pH and concentration of calconcarboxylic acid for quantitative formation of the complex with calcium, effect of acetone on the stability of calcium-calconcarboxylic acid complex and influence of diverse ions on calcium sorption by TBP-loaded PUF. The results show that calcium traces can be separated onto TBP-loaded PUF from 0.25 mol l-1 NaOH at 30 ± 5°C within 30 min. PUF was loaded with TBP in CCl4 (40% v/v). Elution of calcium was done in 1.0 mol l-1 HCl. The calcium formed a complex with calconcarboxylic acid at pH 12 and absorbance was measured at 560 nm in acetone-water medium. Molar absorptivity was found to be 1.082 × 104 l mol-1 cm-1. The method obeys Beer's law from 0.10 to 5.0 µg ml-1 Ca. The validity of the method was established by its successful application in NIST standard reference materials. The method proposed was applied to determine calcium in glass and ceramic materials. The results of the proposed method are comparable with the results of ICP-AES analysis and they are found to be in good agreement.
机译:本文描述了固相萃取系统的应用,以从玻璃和陶瓷中分离痕量钙,用于分光光度法测定。该方法是基于磷酸三正丁酯(TBP)负载的聚氨酯泡沫(PUF)从氢氧化钠溶液中提取钙,然后在盐酸中洗脱。钙调羧酸(2-羟基-1-(2-羟基-4-磺基-1-萘偶氮)-3-萘甲酸)对钙络合物的吸收度的分光光度法在pH 12下进行。研究了以下参数:氢氧化钠浓度和温度对钙提取的影响,定量钙提取的平衡时间,TBP浓度的影响,盐酸浓度对从PUF中钙的定量洗脱的影响,pH值和钙碳羧酸浓度的定量形成钙配合物的性质,丙酮对钙-钙羧酸配合物稳定性的影响以及各种离子对负载TBP的PUF吸附钙的影响。结果表明,在30±5°C的温度下,可以在30分钟内从0.25 mol l-1 NaOH中分离出痕量钙到TBP负载的PUF中。 PUF在CCl4(40%v / v)中加载了TBP。钙的洗脱是在1.0 mol -1 HCl中进行的。钙在pH 12时与钙碳羧酸形成络合物,并在丙酮-水介质中于560 nm处测量吸光度。发现摩尔吸收率是1.082×104μmol-1cm-1。该方法遵循0.10至5.0 µg ml-1 Ca的比尔定律。该方法在NIST标准参考材料中的成功应用证实了该方法的有效性。所提出的方法用于测定玻璃和陶瓷材料中的钙。所提出的方法的结果与ICP-AES分析的结果可比,并且发现它们具有很好的一致性。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号