...
首页> 外文期刊>American Journal of Civil Engineering and Architecture >Development of Wall Construction Material Stabilized with Enset Vegetable Fibers for Rural Housing Units
【24h】

Development of Wall Construction Material Stabilized with Enset Vegetable Fibers for Rural Housing Units

机译:农用住房用新型植物纤维稳定墙体建材的开发

获取原文
           

摘要

The need to develop affordable and durable housing is necessary for both urban and rural dwellers. This study was an attempt to alleviate the building material problem faced in rural dwelling units of these countries by developing nonstructural earthen wall construction material stabilized with enset vegetable fibers. Enset fiber is traditionally harvested from leaves of enset plant as end or byproduct of ‘kocho’. To bring this material in to construction industry the researcher studied its properties and strength as reinforcing material. The dry density of FREB decreased for increased fiber content from 0%-5% and minimum dry density of block at fiber 1.5% of the block. For increased fiber content in FREB, water absorption test failed 0%-1% of fiber content and for 1.5%-5% of fiber content, water absorption is high and the standard specification of water absorption found at 1.5% of fiber content block. Compressive strength of FREB in accordance with ASTM C116-90 is difficult and durability of FREB is done using water absorption and other tests; whereas the flexural strength of FREB is increased with increasing amount of fiber in block. That the researcher highly recommend, earthen block reinforced with enset fiber is low cost, simplest, easily shaped during casting, available where enset growing regions, low energy input, durable when casted properly and plastered well and environmental friendly.
机译:无论是城市还是农村居民,都需要开发负担得起的耐用住房。这项研究是通过开发用镶嵌植物纤维稳定的非结构性土墙建筑材料来减轻这些国家农村居民所面临的建筑材料问题的尝试。传统上,Enset纤维是从Enset植物的叶子中收获的,是“ kocho”的终产物或副产品。为了将这种材料带入建筑行业,研究人员研究了其作为增强材料的性能和强度。随着纤维含量的增加,FREB的干密度从0%-5%降低,并且在纤维块的1.5%处,块的最小干密度降低。对于FREB中增加的纤维含量,吸水率测试无法达到纤维含量的0%-1%,对于纤维含量为1.5%-5%的情况,吸水率很高,吸水率的标准规格为纤维含量的1.5%。 FREB的抗压强度很难达到ASTM C116-90的要求,而FREB的耐久性要通过吸水和其他测试来完成; FREB的抗弯强度随纤维块中纤维含量的增加而增加。研究人员强烈建议,用镶嵌纤维增强的土砌块价格低廉,最简单,在铸造过程中易于成型,可在镶嵌生长区域使用,能量输入低,在正确铸造时经久耐用以及良好的抹灰和环境友好性。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号