Investigation on cutting mechanism in small diameter drilling for GFRP (thrust force and surface roughness at drilled hole wall)

摘要

This study describes the relation between the cutting force and the surface roughness of a drilled hole wall in small-diameter drilling of GFRP for a printed wiring board. In order to investigate the characteristics of small diameter drilling for GFRP, the surface of the drilled hole wall is observed by SEM, and the surface roughness along the feed direction is measured at various edge position angles of the drilled hole. The cutting force during drilling is measured. Moreover, the thrust force is devided into two components (the static component and the dynamic component). It is shown that the dynamic components are related with the surface roughness of the drilled hole wall. In conclusion, it is found that the major cutting edge of the drill is more influential in the quality of the drilled hole wall than the chisel edge of the drill in small diameter drilling of PWB.