...
首页> 外文期刊>IEEE Transactions on Communications >Analysis and modeling of upstream throughput in multihop packet CDMA cellular networks
【24h】

Analysis and modeling of upstream throughput in multihop packet CDMA cellular networks

机译:多跳分组CDMA蜂窝网络中上行吞吐量的分析和建模

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

We consider the problem of throughput modeling of wireless multihop packet CDMA networks with cellular overlay using simple forwarding strategies in the upstream. Considering the effect of shadowing and distance-dependent path loss, we approximate the probability density of interference at each base station (BS) and compare numerical and simulation results for different path-loss parameters. We derive the probability density of the received power at each BS due to transmission of one packet from a random node, as well as the probability distribution of the number of packets received at each node per time slot. Subsequently, we use the above results to approximate the probability density of the total received power at each BS based on calculations of moments. We observe that the probability density of intercell interference due to transmissions from terminals and routers may be approximated by normal and log-normal densities, respectively. We quantify the network performance based on throughput, total consumed power, and outage probability for different system parameters. For homogeneous link efficiencies, introducing routers into the network while reducing the transmission power increases the mean and variance of interference to the desired signal, hence higher outage probability. However, there are ample opportunities inherent to multihop structure, applicable to any of the physical, data link, and network layers, which help increase the overall achievable network throughput.
机译:我们考虑了在上游使用简单转发策略的具有蜂窝覆盖的无线多跳分组CDMA网络的吞吐量建模问题。考虑到阴影和距离相关的路径损耗的影响,我们估算了每个基站(BS)的干扰概率密度,并比较了不同路径损耗参数的数值和仿真结果。由于每个分组从一个随机节点的传输,我们得出每个基站接收功率的概率密度,以及每个时隙在每个节点接收的分组数目的概率分布。随后,我们根据力矩的计算,使用以上结果来估算每个基站处总接收功率的概率密度。我们观察到,由于来自终端和路由器的传输而引起的小区间干扰的概率密度可以分别通过正常和对数-正常密度来近似。我们根据吞吐量,总功耗和不同系统参数的中断概率来量化网络性能。对于同质链路效率,在降低传输功率的同时将路由器引入网络会增加对所需信号的干扰的均值和方差,因此出现中断的可能性更高。但是,多跳结构具有很多固有的机会,适用于任何物理层,数据链路层和网络层,这有助于增加总体上可实现的网络吞吐量。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号