Influence of water-vapor in oxidizer stream on the sooting behavior for laminar coflow ethylene diffusion flames

摘要

The effects of adding water-vapor to the oxidizer stream on soot production in laminar coflow diffusion flames under different oxygen indices (OI) were investigated both experimentally and numerically. A modified coflow Gfilder-type burner was employed to produce the laminar ethylene flames for fifteen different conditions of the oxidizer stream from oxygen-deficient (OI 17%) to oxygen-enriched (OI 25%) conditions, and also without and with adding water-vapor into the oxidizer stream up to 10% on mole basis. The measured soot volume fractions were compared with numerical predictions obtained using the CoFlame code and a chemical kinetic mechanism that consists of reaction pathways up to 5-ring PAHs. The sectional soot model used to simulate the soot particles dynamics considers soot nucleation, surface growth, PAH condensation, oxidation, particle coagulation and fragmentation. Fairly good agreement between experimental and numerical results was found, as close as 1% and 5% of difference in the peak soot volume fraction for 0121% with 0% and 10% of water-vapor addition, respectively. Clear trends of increasing the soot volume fraction (peak and also overall) was observed with increasing OI, while a significant reduction was obtained with the addition of the water-vapor. For the cases analyzed, a reduction of the total soot content was up to 60%. The chemical effects were numerically isolated using non-reacting water-vapor and analyzed, contributing especially to the soot oxidation rates. Finally, a study of the main reaction pathways was performed to better understand the chemical effects of water vapor. The results show that water vapor addition affects the concentrations of H and OH radicals and alters the formation and oxidation of soot precursors. (C) 2019 The Combustion Institute. Published by Elsevier Inc. All rights reserved.