...
首页> 外文期刊>Atmospheric environment >Particle number emission factors and volatile fraction of particles emitted from on-road gasoline direct injection passenger vehicles
【24h】

Particle number emission factors and volatile fraction of particles emitted from on-road gasoline direct injection passenger vehicles

机译:道路汽油直喷乘用车排放的颗粒数排放因子和颗粒的挥发性分数

获取原文
获取原文并翻译 | 示例
           

摘要

Particle number emission factors, and the volatility of the particles, are measured on-road for five gasoline direct injection vehicles over a wide range of operating conditions including urban and highway driving conditions. Two condensation particle counters (CPC) were used to measure nascent and nonvolatile (thermodenuded) particle concentrations for transient urban and highway tests. To measure the non-volatile concentration and also the volatility of the particles, a thermodenuder was employed to remove the semi-volatile material from the aerosol sample. Rapid accelerations were also studied in more detail by measuring the particle size distributions in real-time using a differential mobility spectrometer (DMS). The ratio of semi-volatile particles to total particle number is generally higher during acceleration followed by the idle operating mode. The number emission factors (for particles larger than 2.5 nm) ranged between 5.46 × 10~(11)-3.50 × 10~(12)/km for freshly emitted (nascent) particles and between 2.87 × 10~(11)-3.31 × 10~(12)/km for non-volatile (thermodenuded) particles. More particles per kilometer are produced during acceleration compared to cruise conditions where the non-volatile particle number emission factor for acceleration is 2.3 and 1.8 times higher than vehicle cruise for urban and highway driving cycles, respectively. Particle number emission factor models are also presented in terms of particle emission rate as a function of vehicle tractive power and also as a function of vehicle specific power as defined for the US Environmental Protection Agency's MOVES model.
机译:在道路上针对五种汽油直喷式车辆在包括城市和高速公路驾驶条件在内的各种运行条件下的道路上测量了颗粒数排放因子和颗粒的挥发性。两个凝结粒子计数器(CPC)用于测量瞬态城市和公路测试中的新生粒子和非易失性粒子(热代核)。为了测量颗粒的非挥发性浓度以及挥发性,采用热剥蚀仪从气溶胶样品中除去半挥发性物质。通过使用差动迁移率光谱仪(DMS)实时测量粒度分布,还对快速加速进行了更详细的研究。半挥发性颗粒与总颗粒数之比通常在加速和随后的怠速工作模式期间较高。对于刚发射的(新生的)粒子,发射因子的数量发射因子(对于大于2.5 nm的粒子)在5.46×10〜(11)-3.50×10〜(12)/ km之间,而在2.87×10〜(11)-3.31×之间非易失(热模)颗粒为10〜(12)/ km。与巡航条件相比,在加速过程中每公里产生更多的粒子,在这种情况下,用于加速的非易失性粒子数排放因子分别是城市和高速公路行驶周期中车辆巡航的2.3和1.8倍。颗粒物数量排放因子模型也以颗粒物排放率的形式表示,该速率是车辆牵引力的函数,也是车辆特定功率的函数,如美国环境保护局的MOVES模型所定义。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号