...
首页> 外文期刊>Applied clay science >Solid state and phase transformation mechanism of kaolin sintered with limestone for alumina extraction
【24h】

Solid state and phase transformation mechanism of kaolin sintered with limestone for alumina extraction

机译:高岭土烧结氧化铝萃取的固态和相变理

获取原文
获取原文并翻译 | 示例
           

摘要

The present work aims to investigate the effects of the solid-state thermal reactions at different sintering temperatures on the phase transformation mechanisms and the microstructural changes, the self-disintegration mechanism as well as the efficiency of alumina percent recovery during alumina extraction from kaolin by the lime-sinter process. The sinters were produced at different temperatures within the range 800 degrees C - 1400 degrees C then subjected to leaching process (at the optimum dissociation of 1:5 solid : liquid ratio) by using sodium carbonate solutions (120 g/L) which finally were given to the alumina-pregnant solution. Thermogravimetric analysis (TGA) and differential scanning calorimetry (DSC) were used for characterizing the transformational changes resulted during the thermal reactions between the sintered mineral components in the raw kaolin and limestone samples (i.e., kaolinite and calcite). Microstructural and textural changes of the obtained sinters and sludges were characterized by means of X-ray diffractometry (XRD/XRF), scanning electron microscopy (SEM/EDX) and particle size granulometry. The results indicated that the sintering temperature at 1360 degrees C was the optimum for inducing of the solid-state reaction between the clay and carbonate components with enhancement of alumina productivity by the highest recovery (80.49%). At this superlative sintering condition, the kaolinite was dehydroxylated and transformed into metakaolinite while the calcite was decomposed into calcium oxide, then they reacted together forming to the calcium aluminates that are considered as the highly effective and generative precursor phases in the alumina extraction. Moreover, the obtained sludges were obviously exhibited morphological changes with size enlargements during the leaching process due to the formation of calcium carbonate particles that agglomerated at the surfaces of the insoluble sludge particles.
机译:目前的作品旨在研究固态热反应在不同烧结温度下对相变机制的影响和微观结构变化,自解体机制以及氧化铝百分比氧化铝从高岭土的升高期间的效率石灰烧结过程。通过使用最终碳酸钠溶液(120g / L),在800℃-1400℃的不同温度下在800℃-1400摄氏度的不同温度下产生烧结液(在1:5的最佳解离)(120g / l)中给予氧化铝孕溶液。热重分析(TGA)和差示扫描量热法(DSC)用于表征转化变化,导致烧结矿物组分在未加工高岭土和石灰石样品中的烧结矿物成分(即高岭石和方解石)之间的热反应期间。通过X射线衍射测定(XRD / XRF),扫描电子显微镜(SEM / EDX)和粒度粒度计,表征了所得烧结和污泥的微观结构和纹理变化。结果表明,1360℃的烧结温度是诱导粘土和碳酸酯组分之间固态反应的最佳,通过最高回收率(80.49%)提高氧化铝生产率。在该高级烧结条件下,高羟基钛矿脱羟基化并转化成Metakaolinite,同时将方解石分解成氧化钙,然后它们将形成为氧化铝萃取中被认为是高效和生成的前体相的钙铝合金。此外,由于在不溶性污泥颗粒的表面上凝聚的碳酸钙颗粒的形成,所获得的污泥显然表现出与浸出过程中的尺寸增大的形态变化。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号