Investigation of a microphone height correction for long-range wind farm noise measurements

摘要

In the measurement of wind farm noise, it is standard practice to mount outdoor microphones at a height of 1.5 m. On the other hand, measurements at this height can be affected by wind-induced noise, which has the potential to mask the noise of interest, particularly at low and infrasonic frequencies. Therefore, to minimise wind-induced noise, it is advantageous to measure on or below the ground, where the wind speed is close to zero. However, results from measurements taken at any height other than 1.5 m must be interpreted with caution, due to different interference effects between direct and ground-reflected waves at each location. This investigation explores the feasibility of using a prediction model based on Nord2000 algorithms to correct the 1/3-octave sound pressure level measured at ground level to obtain a representative value for a height of 1.5 m. The model takes into account phase changes due to the difference in travel-time for the direct and reflected rays and finite ground impedance, multiple source contributions and incoherence due to turbulence. The focus is on propagation distances greater than 2 km, where limited validation of existing propagation models has been attempted previously. Comparison is made between the model and measurement results obtained at four locations near a wind farm, where microphones were mounted at a height of 1.5 m and at ground level. A lack of agreement between measurements and the model indicates that the efficient and practical correction method considered here is not feasible for long-range wind farm measurements. Thus, it is recommended that wind farm noise is measured at both 1.5 m (for mid-to high-frequency noise) and at ground level (for low-frequency noise, which is more affected by wind). (C) 2019 Elsevier Ltd. All rights reserved.