首页> 外文期刊>Annals of Operations Research >Locating Active Sensors on Traffic Networks
【24h】

Locating Active Sensors on Traffic Networks

机译:在交通网络上定位有源传感器

获取原文
获取原文并翻译 | 示例
           

摘要

Sensors are used to monitor traffic in networks. For example, in transportation networks, they may be used to measure traffic volumes on given arcs and paths of the network. This paper refers to an active sensor when it reads identifications of vehicles, including their routes in the network, that the vehicles actively provide when they use the network. On the other hand, the conventional inductance loop detectors are passive sensors that mostly count vehicles at points in a network to obtain traffic volumes (e.g., vehicles per hour) on a lane or road of the network. This paper introduces a new set of network location problems that determine where to locate active sensors in order to monitor or manage particular classes of identified traffic streams. In particular, it focuses on the development of two generic locational decision models for active sensors, which seek to answer these questions: (1) "How many and where should such sensors be located to obtain sufficient information on flow volumes on specified paths?", and (2) "Given that the traffic management planners have already located count detectors on some network arcs, how many and where should active sensors be located to get the maximum information on flow volumes on specified paths?" The problem is formulated and analyzed for three different scenarios depending on whether there are already count detectors on arcs and if so, whether all the arcs or a fraction of them have them. Location of an active sensor results in a set of linear equations in path flow variables, whose solution provide the path flows. The general problem, which is related to the set-covering problem, is shown to be NP-Hard, but special cases are devised, where an arc may carry only two routes, that are shown to be polynomially solvable. New graph theoretic models and theorems are obtained for the latter cases, including the introduction of the generalized edge-covering by nodes problem on the path intersection graph for these special cases. An exact algorithm for the special cases and an approximate one for the general case are presented.
机译:传感器用于监视网络中的流量。例如,在运输网络中,它们可用于测量网络给定弧度和路径上的交通量。当读取车辆的识别信息(包括其在网络中的路线)时,本文将涉及一个主动传感器,这些信息是车辆在使用网络时主动提供的。另一方面,常规的电感环路检测器是无源传感器,其主要对网络中的点处的车辆进行计数以获取网络的车道或道路上的交通量(例如每小时的车辆)。本文介绍了一组新的网络位置问题,这些问题确定了在哪里放置有源传感器,以便监视或管理已识别流量流的特定类别。特别是,它着重于为有源传感器开发两个通用的位置决策模型,以寻求回答以下问题:(1)“应放置多少个传感器以及在何处才能获得有关指定路径上流量的足够信息?” ,和(2)“鉴于流量管理规划人员已经在某些网络弧上放置了计数检测器,应该放置多少个有源传感器才能在指定路径上获得最大流量信息?”根据是否存在弧上的计数检测器,如果存在,是否所有弧或其中一部分弧都具有计数检测器,针对三种不同情况制定并分析该问题。有源传感器的位置会在路径流量变量中产生一组线性方程,其解提供路径流量。与设置覆盖问题有关的一般问题显示为NP-Hard,但设计了特殊情况,其中弧仅可携带两条路线,经证明可以多项式求解。对于后一种情况,获得了新的图论模型和定理,包括在这些特殊情况下,在路径交点图上引入了广义的节点边覆盖问题。提出了一种针对特殊情况的精确算法和一种针对一般情况的近似算法。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号