首页> 美国卫生研究院文献>The Open Dentistry Journal >Suppl 2: M6: Relationship Between the Thickness of Cortical Bone at Maxillary Mid-palatal Area and Facial Height Using CBCT
【2h】

Suppl 2: M6: Relationship Between the Thickness of Cortical Bone at Maxillary Mid-palatal Area and Facial Height Using CBCT

机译:补充2:M6:使用CBCT在上Max骨中部区域的皮质骨厚度与面部高度之间的关系

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。

摘要

Introduction : Orthodontic mini-implants have been incorporated into orthodontic treatment modalities. Adequate bone at mini-implant placement site can influence the success or failure of anchorage. The present study was to determine the thickness of cortical bone in the maxillary mid-palatal area at predetermined points for the placement of orthodontic mini-implants using Cone Beam CT technique in order to evaluate the relationship of these values with the facial height. Materials and Methods : A total of 161 patients, consisting of 63 males (39.13%) and 98 females (60.87%), were evaluated in the present study; 38% of the subjects had normal facial height, 29% had short face and 33% had long face. In order to determine which patient belongs to which facial height category, i.e. normal, long or short, two angular and linear evaluations were used: the angle between S-N and Go-Me lines and the S-Go/N-Me ratio. Twenty points were evaluated in all the samples. First the incisive foramen was located. The paracoronal cross-sections were prepared at distances of 4, 8, 16 and 24 mm from the distal wall of the incisive foramen and on each cross-section the mid-sagittal and para-sagittal areas were determined bilaterally at 3- and 6-mm distances (a total of 5 points). The thicknesses of the cortical plate of bone were determined at the predetermined points. Results : There was a significant relationship between the mean cortical bone thickness and facial height (p<0.01), with significantly less thickness in long faces compared to short faces. However, the thickness of cortical bone in normal faces was similar to that in long and short faces. Separate evaluation of the points showed that at point a16 subjects with short faces had thicker cortical bone compared to subjects with long and normal faces. At point b8 in long faces, the thickness of the cortical bone was significantly less than that in short and normal faces. At point d8, the thickness of the cortical bone in subjects with short faces was significantly higher than that in subjects with long faces. Conclusion : At the point a16 the cortical bone thickness in short faces was significantly higher than normal and long faces. The lower thickness of the cortical bone in the palatal area at points b8 and d8 in subjects with long faces might indicate a lower anchorage value of these points in these subjects.
机译:简介:正畸微型植入物已被纳入正畸治疗方式。微型植入物放置部位的骨骼充足会影响锚固的成功或失败。本研究旨在使用锥形束CT技术确定上颌中mid骨区域预定位置上的皮质骨厚度,以放置正畸微型植入物,以评估这些值与面部高度的关系。材料与方法:本研究共评估了161例患者,其中男63例(39.13%),女98例(60.87%)。 38%的受试者面部高度正常,29%的面部短,33%的面部长。为了确定哪个患者属于哪个面部高度类别,即正常,长或短,使用了两个角度和线性评估:S-N和Go-Me线之间的角度以及S-Go / N-Me比率。在所有样品中评估了20分。首先,找到尖锐的孔。在距切开孔的远端壁4、8、16和24 mm处准备冠状旁矢状面,并在每个横断面上分别在3和6处分别确定矢状中和矢状旁区域毫米距离(总共5点)。在预定点确定骨皮质板的厚度。结果:平均皮质骨厚度与面部高度之间存在显着关系(p <0.01),与短脸相比,长脸的厚度显着减小。但是,正常面部的皮质骨厚度与长短面部的相似。对这些要点的单独评估表明,在a16点处,与具有长脸和正常脸的受试者相比,具有短脸的受试者的皮质骨更厚。在长脸的b8点,皮质骨的厚度明显小于短脸和正常脸的厚度。在点d8,短脸受试者的皮质骨厚度明显高于长脸受试者。结论:在a16点,短面部的皮质骨厚度显着高于正常面部和长面部。在长脸受试者中,b点b8和d8处area骨区域的皮质骨厚度较小,可能表明这些点在这些受试者中的锚固值较低。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
代理获取

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号