Introduction. The purpose of this study was to investigate effects of surface treatment of mini-implants in diabetes-induced rabbits by comparing osseointegration around mini-implants. Methods. Twelve New Zealand white rabbits were divided into two groups (alloxan-induced diabetic group and control group). A total of 48 mini-implants were placed after four weeks of diabetic induction. 24 mini-implants were surface-treated with SLA (sandblasted with large grit, and acid etched) and the remaining 24 mini-implants had smooth surfaces. Four weeks after placement, 32 mini-implants were removed from 4 control and 4 diabetic rabbits. Insertion and removal torques were measured. The remaining 16 mini-implants from the two groups were histomorphometrically analyzed. Results. Maximum insertion torque showed no difference between diabetic and control groups, but total insertion energy was higher in control group. In surface-treated mini-implants, maximum removal torque was higher in both diabetic and control groups. Bone-implant contact (BIC) was increased in the control group when compared to the diabetic group. Surface-treated group had higher BIC than smooth surface group in both control and diabetic groups. However, there was no significantly statistical difference. Conclusions. Type 1 diabetes mellitus and surface treatment method of mini-implant affected primary stability of mini-implants. In addition, the use of orthodontic mini-implants in a diabetic patient is likely to show results similar to the healthy patient.
展开▼
