Enhancement of Strength–Ductility Balance of the Laser Melting Deposited 12CrNi2 Alloy Steel Via Multi-step Quenching Treatment

摘要

A ferrite–austenite 12CrNi2 alloy steel additively manufactured by laser melting deposition(LMD) was heat treated by direct quenching(DQ) and tempering inter-critical quenching(TIQ) at 800 ℃ for enhancing its strength–ductility balance. Both heat-treated alloy steels have the martensite–ferrite dual-phase(DP) microstructures. The volume fractions of martensite in the two treated alloy steels are nearly similar(~ 85 vol%), while the sizes of the prior austenitic grain for martensite are different. The martensite-dominated DP microstructure resulted in an obvious improvement in strength–ductility balance of the alloy steel. Compared with the DQ treatment, the multi-step TIQ treatment caused the strength–ductility balance of the alloy steel to be enhanced due to its higher total elongation. The better ductility of the TIQ-treated alloy steel can be attributed to the optimization of the microstructure. The preferred orientation of ferritic grain in the as-deposited alloy steel which was adverse to plastic deformation through dislocation slip was eliminated via the multi-step TIQ treatment. Moreover, the TIQ treatment promoted the formation of finer-grained martensite with larger areas of grain boundaries and twinning boundaries which resulted in the enhancement of the coordinated deformability of the martensite with the ferrite.