Residual stresses of polycrystalline CBN abrasive grits brazed with a high-frequency induction heating technique

摘要

Residual stresses produced in polycrystalline CBN abrasive grits during a high-frequency induction brazing process are calculated by using ?nite element analysis, with a consideration of the nonuniform temperature distribution in the induction brazing model. The in?uences of induction brazing parameters on the residual stresses of polycrystalline CBN abrasive grits have been analyzed, including the embedding depth, grit side length, etc. Results obtained show that the tensile stress with a 40% embedding depth is 292 MPa, which is the minimum on the bonding interface compared with other embedding depths. Meanwhile, the maximum tensile stress is 575 MPa, with an increase of 59% compared with that of a grit side length of 50 mm. Finally, the simulation results of the brazing residual stress of polycrystalline CBN abrasive grits have been con?rmed valid based on the residual stress measurement of the brazed monocrystalline CBN grit.