首页> 外文期刊>海洋学报(英文版) >Seasonal variability in the thermohaline structure of the Western Pacific Warm Pool
【24h】

Seasonal variability in the thermohaline structure of the Western Pacific Warm Pool

机译:西太平洋暖池温盐结构的季节性变化

获取原文
获取原文并翻译 | 示例
       

摘要

Using the 28°C isotherm to define the Western Pacific Warm Pool (WPWP), this study analyzes the seasonal variability of the WPWP thermohaline structure on the basis of the monthly-averaged sea temperature and salinity data from 1950 to 2011, and the dynamic and thermodynamic mechanisms based on the monthly-averaged wind, precipitation, net heat fluxes and current velocity data. ADT=–0.4°C is more suitable than other temperature criterion for determining the mixed layer (ML) and barrier layer (BL) over the WPWP using monthly-averaged temperature and salinity data. The WPWP has a particular thermohaline structure and can be vertically divided into three layers, i.e., the ML, BL, and deep layer (DL). The BL thickness (BLT) is the thickest, while the ML thickness (MLT) is the thinnest. The MLT has a similar seasonal variation to the DL thickness (DLT) and BLT. They are all thicker in spring and fall but thinner in summer. The temperatures of the ML and BL are both higher in spring and autumn but lower in winter and summer with an annual amplitude of 0.15°C, while the temperature of the DL is higher in May and lower in August. The averaged salinities at these three layers are all higher in March but lower in September, with annual ranges of 0.41–0.45. Zonal currents, i.e., the South Equatorial Current (SEC) and North Equatorial Counter Current (NECC), and winds may be the main dynamic factors driving the seasonal variability in the WPWP thermohaline structure, while precipitation and net heat fluxes are both important thermodynamic factors. Higher (lower) winds cause both the MLT and BLT to thicken (thin), a stronger (weaker) NECC induces MLT, BLT, and DLT to thin (thicken), and a stronger (weaker) SEC causes both the MLT and BLT to thicken (thin) and the DLT to thin (thicken). An increase (decrease) in the net heat fluxes causes the MLT and BLT to thicken (thin) but the DLT to thin (thicken), while a stronger (weaker) precipitation favors thinner (thicker) MLT but thicker (thinner) BLT and DLT. In addition, a stronger (weaker) NECC and SEC cause the temperature of the three layers to decrease (increase), while the seasonal variability in salinity at the ML, BL, and DL might be controlled by the subtropical cell (STC).
机译:本研究使用28°C等温线定义了西太平洋暖池(WPWP),根据1950年至2011年的月平均海水温度和盐度数据以及动态和基于月平均风,降水,净热通量和流速数据的热力学机制。 ADT = –0.4°C比其他温度标准更适合用于使用月平均温度和盐度数据确定WPWP上的混合层(ML)和阻挡层(BL)。 WPWP具有特定的热盐结构,可以垂直分为三层,即ML,BL和深层(DL)。 BL厚度(BLT)最厚,而ML厚度(MLT)最薄。 MLT具有与DL厚度(DLT)和BLT类似的季节性变化。它们在春季和秋季都较厚,而在夏季则较薄。 ML和BL的温度在春季和秋季均较高,但在冬季和夏季则较低,年均增幅为0.15°C,而DL的温度在5月较高,8月较低。这三层的平均盐度在3月都较高,而在9月则较低,年均范围为0.41-0.45。纬向流,即南赤道流(SEC)和北赤道逆流(NECC),以及风可能是驱动WPWP热盐结构的季节性变化的主要动力因素,而降水和净热通量都是重要的热动力因素。 。较高(较低)的风会导致MLT和BLT都变厚(变薄),更强(更弱)的NECC会导致MLT,BLT和DLT变薄(变厚),而更强(较弱)的SEC会导致MLT和BLT都变薄。变薄(变薄),DLT变薄(变厚)。净热通量的增加(减少)导致MLT和BLT变厚(变薄),而DLT变薄(变厚),而更强(较弱)的降水量则有利于MLT(变薄)(更薄)但BLT和DLT变厚(变薄) 。另外,更强(更弱)的NECC和SEC导致三层温度降低(升高),而ML,BL和DL盐度的季节性变化可能由亚热带单元(STC)控制。

著录项

  • 来源
    《海洋学报(英文版)》 |2015年第7期|44-53|共10页
  • 作者单位

    Key Laboratory of 0cean Circulation and Waves, Institute of 0ceanology, Chinese Academy of Sciences, Qingdao 266071, China;

    Key Laboratory of 0cean Circulation and Waves, Institute of 0ceanology, Chinese Academy of Sciences, Qingdao 266071, China;

    Key Laboratory of 0cean Circulation and Waves, Institute of 0ceanology, Chinese Academy of Sciences, Qingdao 266071, China;

  • 收录信息 中国科学引文数据库(CSCD);
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

  • 入库时间 2022-08-19 03:57:53
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号