首页> 外文学位 >Investigation of Particle and Gaseous Emissions from Conventional and Emerging Vehicle Technologies Operating on Bio-Fuels.
【24h】

Investigation of Particle and Gaseous Emissions from Conventional and Emerging Vehicle Technologies Operating on Bio-Fuels.

机译:研究使用生物燃料的传统和新兴车辆技术产生的颗粒和气体排放。

获取原文
获取原文并翻译 | 示例

摘要

Light-duty vehicles emit gaseous and particle emissions that have the ability to effect climate, human health, and air quality. Vehicle technologies are changing rapidly due to the need to increase fuel efficiency. The use of biofuels (i.e., ethanol and iso-butanol) may increase due to the desire to reduce the use of fossil fuels. The changes in fuels and vehicle technologies may change the resulting emissions and need to be assessed. For instance, the water-soluble and water-insoluble particle composition could have detrimental health effects. This dissertation investigates the emissions of PM and gaseous emissions from current and emerging vehicle technologies.;The first section of the dissertation discusses a novel technique developed to determine the real-time Water-Insoluble Mass (WIM) fractions of vehicle emissions. The technique is then implemented in the following sections to infer the WIM fraction of vehicle emissions. The next section investigated the PM emissions from a number of hybrid, PFI, and GDI vehicle technologies on ranging aromatic concentrations and octane rating. The next section evaluated the gaseous and particulate emissions from PFI and GDI vehicles on varying concentrations of ethanol and iso-butanol fuels. Ethanol concentration ranged from E10 to E20 and iso-butanol fuels ranged from B16 to B32. The last section of this dissertation examined the gaseous and particle emissions from GDI and FFV technologies from vary concentrations of ethanol and iso-butanol fuels. For the GDI vehicles, ethanol concentration ranging from E10 to E20 and iso-butanol concentrations of B16 to B32 were used. The FFVs used ethanol concentrations were E10, E51, and E83 with an addition iso-butanol blend of B55. PM mass, Particle Size Distributions (PSDs), Particle Number (PN), BC/soot, Water-Soluble Organic Carbon (WSOC), and real-time WIM fractions were measured for the last three sections mentioned. Significant results on particle composition effects from vehicles, fuels, and driving conditions were found. Increasing vehicular speed increased particle hygroscopicity and decreased the WIM fraction. Alcohol concentration decreases the fraction of soot to the total PM mass for the GDI vehicles tested. Generally, increased ethanol concentration decreased the PN and PM mass.
机译:轻型车辆排放的气体和颗粒物具有影响气候,人类健康和空气质量的能力。由于需要提高燃油效率,车辆技术正在迅速变化。由于希望减少化石燃料的使用,生物燃料(即乙醇和异丁醇)的使用可能增加。燃料和车辆技术的变化可能会改变排放量,因此需要进行评估。例如,水溶性和水不溶性颗粒组合物可能具有有害的健康影响。本文研究了当前和新兴的车辆技术中的PM和气态排放物。论文的第一部分讨论了一种用于确定车辆排放物实时水不溶性质量分数的新技术。然后在以下各节中实施该技术以推断车辆排放的WIM分数。下一节研究了各种混合动力,PFI和GDI车辆技术在芳香族浓度和辛烷值范围内的PM排放。下一节评估了不同浓度的乙醇和异丁醇燃料在PFI和GDI车辆中产生的气体和颗粒物排放。乙醇浓度范围从E10到E20,异丁醇燃料范围从B16到B32。本文的最后一部分探讨了GDI和FFV技术从不同浓度的乙醇和异丁醇燃料中产生的气体和颗粒物排放。对于GDI载体,使用的乙醇浓度范围为E10至E20,异丁醇的浓度范围为B16至B32。使用的FFV乙醇浓度为E10,E51和E83,加有异丁醇混合物B55。对于上述最后三个部分,测量了PM质量,粒度分布(PSD),颗粒数(PN),BC /烟灰,水溶性有机碳(WSOC)和实时WIM分数。发现了有关车辆,燃料和驾驶条件对颗粒成分影响的重要结果。车辆速度的增加会增加颗粒的吸湿性并降低WIM分数。对于测试的GDI车辆,酒精浓度降低了烟灰占PM总质量的比例。通常,增加乙醇浓度会降低PN和PM的质量。

著录项

  • 作者

    Short, Daniel Zachary.;

  • 作者单位

    University of California, Riverside.;

  • 授予单位 University of California, Riverside.;
  • 学科 Automotive engineering.;Chemical engineering.
  • 学位 Ph.D.
  • 年度 2014
  • 页码 291 p.
  • 总页数 291
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号