首页> 外文学位 >On-Track Testing as a Validation Method of Computational Fluid Dynamic Simulations of a Formula SAE Vehicle.
【24h】

On-Track Testing as a Validation Method of Computational Fluid Dynamic Simulations of a Formula SAE Vehicle.

机译:现场测试作为SAE配方汽车的计算流体动力学模拟的验证方法。

获取原文
获取原文并翻译 | 示例

摘要

This thesis is about the validation of a computational fluid dynamics simulation of a ground vehicle by means of a low-budget coast-down test. The vehicle is built to the standards of the 2014 Formula SAE rules. It is equipped with large wings in the front and rear of the car; the vertical loads on the tires are measured by specifically calibrated shock potentiometers. The coast-down test was performed on a runway of a local airport and is used to determine vehicle specific coefficients such as drag, downforce, aerodynamic balance, and rolling resistance for different aerodynamic setups. The test results are then compared to the respective simulated results. The drag deviates about 5% from the simulated to the measured results. The downforce numbers show a deviation up to 18% respectively. Moreover, a sensitivity analysis of inlet velocities, ride heights, and pitch angles was performed with the help of the computational simulation.
机译:本论文是关于通过低预算滑行试验验证地面车辆的计算流体动力学模拟的。该车的制造符合2014 Formula SAE规则的标准。它在汽车的前部和后部装有大翼;轮胎上的垂直载荷通过专门校准的减震电位计测量。滑行测试是在当地机场的跑道上进行的,用于确定车辆的特定系数,例如阻力,下压力,空气动力学平衡和针对不同空气动力学设置的滚动阻力。然后将测试结果与相应的模拟结果进行比较。阻力从模拟结果到测量结果偏离了大约5%。下压力数字分别显示高达18%的偏差。此外,借助计算仿真对进气口速度,行驶高度和俯仰角进行了敏感性分析。

著录项

  • 作者

    Weingart, Robert.;

  • 作者单位

    University of Kansas.;

  • 授予单位 University of Kansas.;
  • 学科 Mechanical engineering.;Aerospace engineering.
  • 学位 M.S.
  • 年度 2015
  • 页码 113 p.
  • 总页数 113
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号