Using PCSWMM to simulate first flush and assess performance of extended dry detention ponds as structural stormwater BMPS in a large polluted urban watershed.

摘要

Urbanization and increase of impervious areas impact stormwater runoff and can pollute receiving waters. Total suspended solids (TSS) are of particular concern as they can act as a transport agent for other pollutants. Moreover, the existence of the first flush phenomenon (FF), whereby the first stage of storm runoff is the most concentrated, can also have profound ecological effects on receiving waters. Understanding the various types of pollutants in watershed stormwater, their correlation with rainfall parameters (precipitation depth and previous dry days) and with TSS, and the existence of FF is crucial to the design of the most suitable structural best management practice (BMP) that can mitigate their harm. Personal Computer Storm Water Management Model (PCSWMM) is a well-known computer model that can simulate urban runoff quantity and quality and model BMPs. The use of PCSWMM to simulate the first flush phenomenon and to evaluate the effectiveness of structural BMPs has not been previously investigated for a large urban watershed with seriously polluted stormwater runoff.;This research is concerned with the study of a framework for designing structural best management practices (BMPs) for stormwater management in a large watershed that is based on comprehensive analysis of pollutants of concern, rainfall parameters of influence, and the existence of FF. The framework was examined using the PCSWMM computer model in the St Anthony Park watershed, an urban watershed in St Paul, Minnesota with a large drainage area of 3,418 acres that discharges directly into the Mississippi River via a storm tunnel. A comprehensive study was undertaken to characterize the overall St. Anthony Park watershed stormwater quality trends for the period of record 2005-2013 for heavy metals, nutrients (ammonia and total phosphorus), sediment (TSS), and bacteria (E. coli). Stormwater was found to be highly contaminated as measured by exceedance of the Minnesota Pollution Control Agency (MPCA) water quality standards and as compared to data obtained from the National Stormwater Quality Database (NSQD). None of the examined parameters significantly correlated with precipitation depth. Concentrations of most heavy metals, total phosphorus and TSS positively correlated with previous dry days, and most pollutants correlated positively with TSS, which provided a strong rationale for using TSS as a representative pollutant in PCSWMM and in examining BMP efficiency. Moreover, BMPs that targeted the particulate fraction in stormwater would be the most efficient in reducing stormwater pollution.;A PCSWMM model was built based on the existing drainage system of the watershed, which consisted of inlet structures, manholes, pipes and deep manholes that connect the network pipes to a deep drainage tunnel discharging directly into Mississippi River.;Extended dry detention ponds (EDDPs) are basins whose outlets are designed to detain stormwater runoff for a calculated time that allows particles and associated pollutants to settle. Extended dry detention ponds are a potential BMP option that could efficiently control both water quantity (by diverting initial volumes of stormwater, thus addressing FF) and quality (by reducing suspending pollutants, thus addressing TSS and co-contaminants). Moreover, they are the least-expensive stormwater treatment practice on a cost per treated unit area. Two location-based designs were examined. The first was an EDDP at the main outfall (OFmain), while the second was a set of seven smaller EDDPs within the vicinity of deeper manholes of the deep tunnel (distributed EDDPs). Distributed EDDPs were similar to the OFmain EDDP at reducing peak stormwater flow (52-61%) but superior in reducing TSS loads (20-25% for small particles and 43-45% for larger particles based on the particle sedimentation rate removal constant k) and in reducing peak TSS loads (67-75%). These efficiencies were obtained using the dynamic and kinematic wave routing methods, indicating that they could be used interchangeably for this watershed. The steady state routing method produced unrealistic results and was subsequently excluded from FF analysis. Distributed EDDPs were superior to OFmain EDDP at eliminating FF per the stringent fifth definition (Delta > 0.2). This was true for small values of k. However, larger values of k and other FF tests (above the 45º no-flush line and FF coefficient b < 1) showed that BMP implementation overall failed to completely eliminate FF. This suggested that the extended time required by EDDPs to efficiently remove pollutants from stormwater via settling would compromise their ability to completely eliminate FF.;In conclusion, a comprehensive framework was applied so as to better design the most efficient BMPs by characterizing the overall St. Anthony Park watershed stormwater pollutants, their correlation with rainfall parameters and with TSS, and the magnitude of FF. A cost-effective, rapid, and accurate method to simulate FF and study the optimal BMP design was thus implemented for a large urban watershed through the PCSWMM model. (Abstract shortened by UMI.).