首页> 外文学位 >LABORATORY STUDIES OF SUBMICRON PARTICLE FORMATION IN PULVERIZED COAL COMBUSTION.
【24h】

LABORATORY STUDIES OF SUBMICRON PARTICLE FORMATION IN PULVERIZED COAL COMBUSTION.

机译:煤粉燃烧中亚微米颗粒形成的实验室研究。

获取原文
获取原文并翻译 | 示例

摘要

A laboratory furnace was constructed to study the mechanism of submicron particle formation in pulverized coal boilers. Simulation was achieved by matching characteristic kinetic times in laboratory and field units. This was done by matching volumetric heat extraction rates. Reynolds number and geometric scaling were not deemed essential for the simulation.;The influence of macroscopic combustion parameters on the characteristics of fine particle emissions was investigated. Total submicron particle volume concentration was found to depend on burner type and to increase with temperature for each burner type tested. The particle volume concentration was found to increase with exhaust NO concentration.;The fine particle composition was found to differ from that of larger residual ash particles which generally reflected the composition of the bulk ash. It was also found that combustion conditions (overall fuel-air equivalence ratio and wall temperature) influenced the composition of the smallest ash particles.;Species enrichment data are generally supportive of the vaporization-condensation mechanism of submicron particle formation. Measured dependence of particle volume-mean diameter is consistent with theoretical predictions based on free-molecular Brownian coagulation of particles formed by nucleation of vaporized ash. Strong dependence of submicron particle volume concentration on char particle temperatures in the hot zone further suggests vaporization of ash to be the principal source of material from which fine particles are formed.;Combustion-generated submicron aerosols from the laboratory furnace were characterized by size and composition distribution measurements using an electrical mobility analyzer and a low-pressure impactor. Elemental analysis of size-classified mass samples was done by alpha particle-induced X-ray emission spectrum analysis.;A semi-quantitative combustion model was formulated to calculate char particle temperature-time histories in the laboratory furnace. An Arrhenius vaporization rate expression was fitted to the laboratory measurements of total submicron particle volume concentration using the particle temperature histories calculated from the combustion model. Estimates of kinetic parameters were compared with those of other investigators. The model calculations suggest that the mass-specific rate of ash vaporization is strongly dependent on parent coal particle size. This is due to higher burning temperatures of smaller particles together with a high apparent activation energy for ash vaporization.;Recommendations for further work are given.
机译:建造了一个实验室炉,研究粉煤锅炉中亚微米颗粒形成的机理。通过匹配实验室和现场单位的特征动力学时间来实现仿真。这是通过匹配体积排热速率来完成的。雷诺数和几何定标不是模拟所必需的。;研究了宏观燃烧参数对细颗粒排放特征的影响。发现总的亚微米颗粒体积浓度取决于燃烧器类型并且对于每种测试的燃烧器类型都随着温度而增加。发现颗粒体积浓度随废气中NO浓度的增加而增加。发现细颗粒的组成不同于较大的残留灰分颗粒,后者通常反映了块状灰的组成。还发现燃烧条件(总的燃料-空气当量比和壁温)影响最小的灰烬颗粒的组成。物种富集数据通常支持亚微米颗粒形成的汽化-冷凝机理。所测得的颗粒体积-平均直径的依赖性与基于由汽化灰分成核形成的颗粒的自由布朗布朗凝聚的理论预测一致。亚微米颗粒体积浓度对热区炭颗粒温度的强烈依赖性进一步表明,灰分的汽化是形成细颗粒的主要材料来源。实验室炉燃烧产生的亚微米气溶胶的大小和组成具有特征使用电动迁移率分析仪和低压冲击器进行分布测量。通过α粒子诱导的X射线发射光谱分析对尺寸分类的质量样品进行元素分析。;建立了半定量燃烧模型,以计算实验室炉中炭颗粒温度-时间的历史记录。使用从燃烧模型计算得出的颗粒温度历史记录,将Arrhenius汽化速率表达式拟合到总亚微米颗粒体积浓度的实验室测量值。动力学参数的估计值与其他研究者进行了比较。模型计算表明,灰分气化的质量比速率很大程度上取决于母体煤的粒径。这是由于较小颗粒的较高燃烧温度以及灰分汽化的较高表观活化能所引起的;给出了进一步工作的建议。

著录项

  • 作者

    TAYLOR, DEAN DALTON.;

  • 作者单位

    California Institute of Technology.;

  • 授予单位 California Institute of Technology.;
  • 学科 Engineering Mechanical.;Energy.
  • 学位 Ph.D.
  • 年度 1981
  • 页码 314 p.
  • 总页数 314
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号