首页> 外文学位 >HYDRODYNAMICS AND AXIAL MIXING IN A THREE-PHASE BUBBLE COLUMN.
【24h】

HYDRODYNAMICS AND AXIAL MIXING IN A THREE-PHASE BUBBLE COLUMN.

机译:三相泡沫柱中的流体动力学和轴向混合。

获取原文
获取原文并翻译 | 示例

摘要

The aim of this experimental study was to provide a better understanding of the current state of the field of the multiphase hydrodynamic and mixing characteristics. The fluid dynamics of three-phase cocurrent flow in a 15.2 cm diameter by 335 cm long bubble column were studied. Behavior of gas liquid and solids holdups, slurry-phase axial mixing and flow regime transition in gas-liquid-solid systems were investigated by varying a number of parameters such as particle size (10-70 microns), solids concentration (10-40%, by weight), superficial gas velocity (3-30 cm/sec), and superficial slurry velocity (0-10 cm/sec). Data for gas holdup were analyzed by the hydrostatic-head-technique from the pressures measured by a series of "u" tube manometers at different axial locations. To determine the solid and liquid holdups in the three-phase mixtures, solid-liquid samples, collected at several locations along the length of the column, were used. The solids concentration in the sampled slurry was measured gravimetrically. Temperature profiles were obtained during the continuous addition of heat as a tracer under steady-state conditions. This data were analyzed by the one-dimensional axial dispersion model. Gas holdup was found to increase with the increasing gas velocity, but decreased with liquid velocity, solids content and particle size. Liquid holdup decreased with increasing gas velocity and solids content, but it increased with increasing slurry velocity and particle size. Similar behavior was observed for solids holdup. The heat dispersion coefficients were found to increase with gas velocity, to be independent of solids concentration. They decreased with both increasing slurry velocity and increasing size of the solids over the ranges studied. Comparison of the heat dispersion coefficients with the mass dispersion coefficients indicated that the dispersion coefficients for both heat and mass were equivalent. Flow regime maps were also determined by relating drift flux and gas holdup. Most of the present data fell in the turbulent bubbling or transition region. The effects of solids concentration, particle size, and slurry velocity on the prevailing flow regimes were found to be significant. An increase in values of all these parameters caused an earlier deviation from bubble flow regime. The experimental data for flow regimes, gas holdup and dispersion coefficient were empirically correlated and frequently compared with the existing data and correlations, found in the literature.
机译:该实验研究的目的是提供对多相流体动力和混合特性领域的当前状态的更好理解。研究了在直径为15.2厘米,长为335厘米的鼓泡塔中三相并流的流体动力学。通过改变许多参数,例如粒径(10-70微米),固体浓度(10-40%),研究了气液固固物的行为,气液固相系统中的浆相轴向混合和流态转变。 (按重量计),表观气体速度(3-30厘米/秒)和表观浆液速度(0-10厘米/秒)。通过静水压头技术从一系列“ u”型管压力计在不同轴向位置所测得的压力来分析含气量数据。为了确定三相混合物中的固含量和液体含量,使用了沿色谱柱长度在多个位置收集的固液样品。用重量分析法测量样品浆中的固体浓度。在稳态条件下连续添加热量作为示踪剂时获得温度曲线。通过一维轴向弥散模型对该数据进行了分析。发现气体滞留率随气体速度增加而增加,但随液体速度,固体含量和粒径而减少。持液率随气体速度和固体含量的增加而降低,但随浆液速度和粒径的增加而增加。对于固含量,观察到类似的行为。发现热扩散系数随气体速度而增加,与固体浓度无关。在研究的范围内,它们随着浆液速度的增加和固体粒度的增加而降低。热扩散系数与质量扩散系数的比较表明,热量和质量的扩散系数是相等的。还通过关联漂移通量和气体滞留率来确定流态图。目前的大多数数据都位于动荡的起泡或过渡区域。发现固体浓度,粒度和浆液速度对主要流动形式的影响是显着的。所有这些参数值的增加导致较早地偏离气泡流动状态。对流态,气体滞留率和弥散系数的实验数据进行了经验关联,并经常与文献中的现有数据和关联进行比较。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号