首页> 外文学位 >SURFACE CURRENT AND AC LOSS IN SUPERCONDUCTING NIOBIUM-TIN.
【24h】

SURFACE CURRENT AND AC LOSS IN SUPERCONDUCTING NIOBIUM-TIN.

机译:超导铌锡中的表面电流和交流损耗。

获取原文
获取原文并翻译 | 示例

摘要

The unexpectedly low hysteretic energy loss of the high temperature A-15 superconductor niobium-tin was investigated with three generations of flux penetration measurement apparatus. The samples were a variety of electron-beam coevaporated films on Hastelloy tubes. Many of the samples were multilayer composites of niobium-tin with normal metal barrier layers from 9 to 250 nm thick.; An inductive ac loss measurement system was developed first, which used a self-resonant field magnet and probe mounted sample in a dual-dewar for temperature control. A balanced pair of detection coils and digital signal averaging gave unambiguous ac loss measurements. Those samples with very high ac losses were explained by the critical state model and volume critical currents consistent with dc measurements. Most of the low loss samples involved strong surface effects, however, which were not consistent with known mechanisms. The measured high-resolution electric field waveforms of these low loss samples were analyzed in a form readily comparable with previous model calculations.; The apparatus was then modified to measure ac waveforms in a dc bias field, allowing additional comparisons by separating surface and volume currents. Finely layered super-conductors were found to have greatly enhanced volume pinning of vortices. The large columnar grains in thick single layers were found to have homogeneous pinning.; To further separate the surface-effect current into superheating and supercooling components, an apparatus was developed to detect the response of a single initial field change. Results of several samples showed: (1) the flux exit field was equal to the surface induction, as expected, (2) the magnitude and field dependence of the low-field flux entry barrier were at least a factor of three smaller than expected for an ideal surface, (3) the Meissner effect was directly observable below about 200 Oe, (4) the effective superheating surface barrier of internal layers was small, but enhancements of desirable morphology and bulk pinning force were enormous, and (5) the entry barrier was severely degraded by trapped reverse-sign vortices. The latter is consistent with published tunneling and microwave resistivity measurements, and is qualitatively consistent with L. Kramer's (1973) theoretical study of the stability limit of the superheated state.
机译:用三代磁通穿透测量仪研究了高温A-15超导体铌锡的出乎意料的低滞后能量损耗。样品是在哈氏合金管上的各种电子束共蒸发膜。许多样品是铌-锡的多层复合材料,具有9至250 nm厚的常规金属阻挡层。首先开发了一种感应式交流损耗测量系统,该系统使用自谐振场磁体和双杜瓦瓶中的探头安装样品进行温度控制。一对平衡的检测线圈和数字信号平均可以清楚地测量交流损耗。临界状态模型和与直流测量结果一致的体积临界电流解释了那些交流损耗非常高的样品。大多数低损耗样品都具有很强的表面效应,但这与已知机理不符。这些低损耗样品的测量高分辨率电场波形以易于与先前模型计算相比的形式进行了分析。然后对设备进行了修改,以测量直流偏置场中的交流波形,从而通过分离表面电流和体积电流进行其他比较。发现精细的超导体具有大大增强的旋涡体积钉扎。发现厚单层中的大柱状晶粒具有均匀的钉扎。为了将表面效应电流进一步分为过热和过冷成分,开发了一种设备来检测单个初始场变化的响应。几个样品的结果表明:(1)磁通出射场等于表面感应,正如预期的那样;(2)低场磁通进入势垒的大小和场依存性比预期的小至少三倍。一个理想的表面,(3)在约200 Oe以下可直接观察到迈斯纳效应,(4)内层的有效过热表面屏障很小,但所需形态和整体钉扎力的增强很大,并且(5)进入势垒被捕获的反向符号涡旋严重破坏。后者与已发表的隧穿和微波电阻率测量结果一致,并且在质量上与L. Kramer(1973)对过热状态稳定性极限的理论研究一致。

著录项

  • 作者

    NORTON, ROBERT HENRY.;

  • 作者单位

    Stanford University.;

  • 授予单位 Stanford University.;
  • 学科 Physics Condensed Matter.
  • 学位 Ph.D.
  • 年度 1983
  • 页码 172 p.
  • 总页数 172
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类 O49;
  • 关键词

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号