首页> 外文学位 >Calcium sulfate scale formation and control in nanofiltration of agricultural drainage water.
【24h】

Calcium sulfate scale formation and control in nanofiltration of agricultural drainage water.

机译:农业排水纳米过滤中硫酸钙垢的形成与控制。

获取原文
获取原文并翻译 | 示例

摘要

Experimental studies with real drainage water samples and model solutions were conducted to evaluate scale formation and control by antiscalant treatment. Experiments were conducted in glassware and with a plate-and-frame nanofiltration (NF) membrane recirculation unit. Membrane experiments consisted of two types: permeate disposal to measure the effect of recovery increase, and feedwater recirculation at a specific concentration factor (CF) to establish the change of performance with time. A mathematical expression relating recovery to feedwater CF has been developed.; Incipient nuclei formation was observed in glassware experiments and related to ionic strength and concentration of calcium and sulfate ions. Membrane experiments showed that a continued surface reaction was the cause of gypsum scale once the corresponding crystallization CF was reached. On the other hand, calcium carbonate scale resulted from a continuous increase in concentration factor. There is a high probability that both scales result from precipitate particles formed in the concentration polarization layer and deposited on the membrane surface.; Specific glassware and membrane experiments showing the concentration polarization modulus (CPM) dependence on permeate flux compared very well with an equation based on semi-empirical mass transfer correlation. A proportionality factor, independent from ionic composition, represents the discrepancy between saturation level (CFsat) predicted by a sophisticate gypsum solubility model and actual crystallization (CF cryst) observed in glassware experiments. A reference aquatic humic acid significantly retarded scaling by tying up calcium ions that would have otherwise been used for the formation of incipient nuclei. Commercial polyacrylic acid (PAA) proved to be an effective antiscalant. The relationship between PAA dosage and CF of model solutions fitted a parabolic-type curve. It is hypothesized that PAA inhibits crystallization by coating the surface of nuclei.; Experimental findings were combined into a model, which predicts PAA dosage required for calcium sulfate scale control in nanofiltration of any given saline solution. Maximum product recovery was 60% with one type of drainage water and 80% with another. Operating pressures were 225 psi and 330 psi, respectively, thereby showing considerable improvement in performance, compared with pressures required by conventional reverse osmosis membranes used in earlier attempts at drainage water reclamation.
机译:进行了实际排水水样和模型溶液的实验研究,以评估水垢的形成和防垢剂处理的控制。实验是在玻璃器皿中进行,并使用板框式纳滤(NF)膜再循环装置进行。膜实验包括两种类型:渗透物处理以测量回收率增加的影响,以及给水在特定浓度因子( CF )再循环以确定性能随时间的变化。已经开发出与给水 CF 的回收率有关的数学表达式。在玻璃器皿实验中观察到初始核形成,并且与离子强度以及钙离子和硫酸根离子的浓度有关。膜实验表明,一旦达到相应的结晶CF,连续的表面反应就是石膏结垢的原因。另一方面,碳酸钙结垢是由于浓度因子的持续增加所致。这两种水垢很有可能是由在浓差极化层中形成并沉积在膜表面上的沉淀颗粒引起的。特定的玻璃器皿和膜实验显示出浓度极化模量(CPM)对渗透通量的依赖性,与基于半经验传质相关性的方程式进行了很好的比较。比例因子与离子组成无关,代表复杂的石膏溶解度模型预测的饱和度水平( CF sat )与实际结晶度( CF cryst )在玻璃器皿实验中观察到。参比水生腐殖酸通过束缚钙离子而显着延迟了水垢的形成,否则钙离子会被用于形成初始核。商业聚丙烯酸(PAA)被证明是一种有效的防垢剂。 PAA剂量与模型溶液的 CF 之间的关系符合抛物线型曲线。假设PAA通过覆盖核表面来抑制结晶。将实验结果组合到一个模型中,该模型预测了在任何给定盐溶液的纳滤中硫酸钙垢控制所需的PAA剂量。一种排水方式的最大产品回收率为60%,另一种排水方式的最大回收率为80%。与较早尝试进行排水再生的传统反渗透膜所需的压力相比,工作压力分别为225 psi和330 psi,从而显示出性能上的显着改善。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号