首页> 外文学位 >Development of novel microbial sensors to measure easily degradable organic substances in wastewater.
【24h】

Development of novel microbial sensors to measure easily degradable organic substances in wastewater.

机译:新型微生物传感器的开发,可测量废水中易降解的有机物质。

获取原文
获取原文并翻译 | 示例

摘要

This study describes the development of Biochemical Oxygen Demand (BOD) sensors that are portable and applicable in fresh and salt-containing wastewater. The fundamental principle of these BOD sensors is the immobilization of living microbial cells both on Clark oxygen electrodes and miniaturized thick film oxygen electrodes. The oxygen consumption by the microbial cells in metabolizing the organic pollutants is easily measured by these sensors.;The yeast strain Arxula adeninivorans LS3 was chosen because of its salt-tolerance, wide substrate spectrum and robustness. It is immobilized best in a hydrogel, polycarbamoyl sulfonate (PCS). The gel can attach to a Pt electrode surface and consequently, can be applied as a thick film oxygen electrode. A first BOD sensor prototype was constructed with immobilized Arxula cells in a membrane on a Clark-type oxygen electrode. The BOD values of real domestic wastewater from the sensor and from BOD, tests correlate well. The BOD sensor can thus be used for rapid estimation of BOD.;In order to reduce the size of the BOD sensor, an oxygen electrode fabricated by thick film technology was investigated. The oxygen measuring range, working potential and stability proved to be suitable for application in dissolved oxygen measurement. The Arxula cells are directly immobilized in PCS hydrogel on the thick film oxygen electrode. The apparent biocatalyst kinetic constant KM and Vmax are shown to be higher than those of non-immobilized free cells. The linear range and sensitivity are therefore higher for the immobilized cell sensor. The linear range can be increased further by coating extra layers of PCS gel on top of the cell layer to generate a higher diffusion barrier for the oxygen and substrates.;Electrochemical interferences have to be minimized because the thick film sensor is constructed without a gas selective permeable membrane. Cobalt(II) tetra(3-methoxy-4-hydroxyl-phenyl) porphyrin (CoTMHPP) was immobilized in the PCS gel and it performed as a catalyst for oxygen reduction. The two rate affecting factors of immobilized mediators: the charge transfer diffusivity and the oxygen reduction rate are found to be higher than the oxygen diffusivity and the apparent Vmax of the Arxula cells respectively These results showed that the kinetics of the sensor is not dependent on the PCS hydrogel immobilized CoTMHPP mediator but on the metabolism of the cells and thus CoTMHPP is a good electrocatalyst. The Arxula cells were immobilized on the top of a CoTMHPP modified thick film electrode. The apparent KM and V max are similar to the Arxula sensor without the CoTMHPP mediator. Coimmobilization of Arxula and CoTMHPP results in a less efficient electron transfer but an increase in the linear range of applications.;The BOD values obtained from the thick film sensor with the immobilized CoTMHPP catalyst are comparable to the first BOD sensor prototype in domestic wastewater measurement. For the first time in the literature, both a stationary and a pocket sized microbial sensor have been developed that work under the real site operating conditions of East Asia. (Abstract shortened by UMI.).
机译:这项研究描述了便携式生化需氧量(BOD)传感器的发展,适用于新鲜和含盐废水。这些BOD传感器的基本原理是将活的微生物细胞固定在Clark氧电极和小型化的厚膜氧电极上。这些传感器可以很容易地测量微生物细胞代谢有机污染物时的耗氧量。选择酵母菌株Arxula adeninivorans LS3是因为它具有耐盐性,宽的底物谱和坚固性。它最好固定在水凝胶中,聚氨基甲酰基磺酸盐(PCS)。该凝胶可以附着在Pt电极表面上,因此可以用作厚膜氧电极。使用在Clark型氧电极上的膜中固定有Arxula细胞的方法构建了第一个BOD传感器原型。来自传感器和BOD的实际生活废水的BOD值与测试之间的相关性很好。因此,可以将BOD传感器用于BOD的快速估算。为了减小BOD传感器的尺寸,研究了采用厚膜技术制造的氧电极。氧气测量范围,工作电位和稳定性证明适合用于溶解氧测量。 Arxula细胞直接固定在厚膜氧电极上的PCS水凝胶中。表观的生物催化剂动力学常数KM和Vmax被显示出高于未固定的游离细胞。因此,固定式细胞传感器的线性范围和灵敏度更高。可以通过在细胞层的顶部涂覆额外的PCS凝胶层来进一步提高线性范围,以对氧气和底物产生更高的扩散势垒。由于厚膜传感器的构造没有气体选择性,因此必须将电化学干扰降至最低渗透膜。四(3-甲氧基-4-羟基苯基)钴(II)卟啉(CoTMHPP)被固定在PCS凝胶中,并作为氧还原催化剂。固定介体的两个速率影响因素:电荷转移扩散率和氧气还原率分别高于Arxula细胞的氧气扩散率和表观Vmax。这些结果表明,传感器的动力学不依赖于PCS水凝胶固定了CoTMHPP介体,但对细胞的代谢无影响,因此CoTMHPP是良好的电催化剂。将Arxula细胞固定在CoTMHPP修饰的厚膜电极的顶部。表观KM和V max与没有CoTMHPP介体的Arxula传感器相似。 Arxula和CoTMHPP的共固定化导致电子转移效率降低,但线性应用范围增加;从厚膜传感器与固定的CoTMHPP催化剂获得的BOD值可与家用废水测量中的第一个BOD传感器原型媲美。在文献中,固定式和袖珍型微生物传感器都已首次开发出来,可在东亚的实际工地条件下工作。 (摘要由UMI缩短。)。

著录项

  • 作者

    Chan, Chiyui.;

  • 作者单位

    Hong Kong University of Science and Technology (Hong Kong).;

  • 授予单位 Hong Kong University of Science and Technology (Hong Kong).;
  • 学科 Chemistry Analytical.;Engineering Chemical.;Environmental Sciences.;Engineering Environmental.
  • 学位 Ph.D.
  • 年度 1999
  • 页码 221 p.
  • 总页数 221
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号