首页> 外文学位 >Quantitative trait loci (QTL) analysis of yield components and heat tolerance in wheat (Triticum aestivum).
【24h】

Quantitative trait loci (QTL) analysis of yield components and heat tolerance in wheat (Triticum aestivum).

机译:小麦(Triticum aestivum)产量构成和耐热性的数量性状基因座(QTL)分析。

获取原文
获取原文并翻译 | 示例

摘要

This study was conducted to identify and map QTLs for yield components and heat tolerance of wheat in response to two kinds of heat treatment (short term-and long term-heat treatment) during seed formation in a set of 62 RILs derived from a cross of ‘7C’ (heat resistant variety) and ‘Seri M82’ (heat susceptible variety) in environmentally controlled growth rooms and field. Phenotypic variations of yield components (kernel number, kernel weight, spike number and grain filling duration) were evaluated as indicators of heat tolerance/susceptibility. Most of the phenotypic variations of yield components exhibited a normally distributed pattern in response to heat stress treatments. This suggests that the yield component responses to high temperature stress are likely quantitatively inherited. A transgressive segregation pattern compared to the two parents was observed in several yield traits. This suggests that genetic variation from optimal recombination from the two parents have occurred in the progeny population. The Pearson correlation coefficients revealed significant correlations between yield components. This suggests the probability of co-segregation of genes controlling each yield components. The ANOVA also revealed a significant genotype x environment effect on individual yield components in response to reproductive stage high temperature stress. The heritability of the individual yield components was low (0.42 to 25%, 0.1∼2% for heat tolerance). One hundred two polymorphic SSRs markers among 323 SSRs markers tested were used to construct a linkage coverage and average interval distance of 1860.2 cM and 18.2 cM/marker, respectively. Eighty-one QTLs for yield components and 68 QTLs for heat tolerance were detected with high LOD values (2.50∼8.35 for yield components, 2.51∼9.37 for heat tolerance) and that explained significant phenotypic variations (7∼40% for individual QTL for yield components, 2∼40 % for individual heat tolerance QTLs) from seven individual environments and the four individual heat stress environments, respectively. Specifically the regions between wmc48 and wmc89, and between wmc622 and wmc332 on the chromosome 4A and 6A, respectively possessed QTLs for both yield components and heat tolerance from various environments.
机译:这项研究的目的是确定和绘制QTLs,这些QTLs是由一组来自62个RIL的62个RIL组成的,它们在种子形成过程中响应两种热处理(短期和长期热处理)对小麦的产量组成和耐热性的影响。在环境受控的生长室和田地中使用“ 7C”(耐热品种)和“ Seri M82”(耐热品种)。评价了产量成分的表型变化(仁数,仁重,穗数和籽粒灌浆持续时间)作为耐热性/敏感性的指标。响应于热应激处理,大多数屈服成分的表型变化表现出正态分布的模式。这表明屈服分量对高温应力的响应很可能是遗传的。与几个亲本相比,在两个产量性状上发现了一种过分的分离模式。这表明在后代群体中已经发生了来自两个亲本的最佳重组的遗传变异。皮尔逊相关系数揭示了产量成分之间的显着相关性。这表明控制每个产量成分的基因共分离的可能性。方差分析还揭示了对生殖阶段高温胁迫响应的基因型x环境对个体产量构成的显着影响。单个产量成分的遗传力很低(0.42%至25%,耐热性为0.1〜2%)。测试的323个SSR标记中的102个多态SSR标记用于构建连锁覆盖范围,平均间隔距离分别为1860.2 cM和18.2 cM / mark。检测到了81个产量成分的QTL和68个耐热性QTL,具有较高的LOD值(产量成分为2.50〜8.35,耐热性为2.51〜9.37),这说明了显着的表型变异(单个产量QTL为7-40%)组件,分别来自七个独立环境和四个独立热应力环境的2%至40%的独立耐热QTL)。具体而言,染色体4A和6A上wmc48和wmc89之间以及wmc622和wmc332之间的区域分别具有QTL,这些QTL既能获得来自各种环境的产量成分又具有耐热性。

著录项

  • 作者

    Do, Jung Hwa.;

  • 作者单位

    Texas A&M University.;

  • 授予单位 Texas A&M University.;
  • 学科 Agriculture Agronomy.;Biology Genetics.;Biology Molecular.
  • 学位 Ph.D.
  • 年度 2007
  • 页码 164 p.
  • 总页数 164
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号