首页> 外文会议>Optoelectronic Devices: Physics, Fabrication, and Application II >5.3 W cw output power from a Master Oscillator Power Amplifier at 1083 nm
【24h】

5.3 W cw output power from a Master Oscillator Power Amplifier at 1083 nm

机译:来自主振荡器功率放大器的5.3 W cw输出功率在1083 nm

获取原文
获取原文并翻译 | 示例

摘要

A master-oscillator power-amplifier system at λ=1083nm with 5.3 Watt output power and a narrow spectral linewidth was realised. The master oscillator was a distributed Bragg reflector (DBR) laser with a 3-μm wide ridge waveguide (RW) and a total length of 2 mm. The power amplifiers were a 4 mm long antireflection coated tapered laser diodes with 500 μm or 1000 μm long straight RW sections. At a temperature of 40℃ and an injection current of 160 mA, the DBR laser had a wavelength of 1083 nm. The emitted light of the DBR laser was focused into the tapered amplifier with a seed power of up to 36 mW. At 10℃ and at a current through the tapered amplifier of 8.6 A, a maximum output power of 5.3 W was measured. Over the full operating range single longitudinal mode operation at a wavelength of λ=1083 nm was maintained with a side mode suppression ratio better than 35 dB. The vertical far field angle was below 22° (FWHM).
机译:实现了一个主振荡器功率放大器系统,其波长为λ= 1083nm,输出功率为5.3瓦,光谱线宽较窄。主振荡器是具有3μm宽脊形波导(RW),总长度为2 mm的分布式布拉格反射器(DBR)激光器。功率放大器是一个4毫米长的抗反射涂层锥形激光二极管,具有500μm或1000μm长的直RW截面。在40℃的温度和160 mA的注入电流下,DBR激光器的波长为1083 nm。 DBR激光的发射光以高达36 mW的种子功率聚焦到锥形放大器中。在10℃且通过锥形放大器的电流为8.6 A时,测得的最大输出功率为5.3W。在整个工作范围内,以λ= 1083 nm的波长保持单纵模工作,其旁模抑制比优于35 dB。垂直远场角低于22°(FWHM)。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号