首页> 外文会议>IEEE International Conference on Consumer Electronics - Asia >Data rate increasing method using multiple PN sequences for the superposed PNs on broadcasting system signals
【24h】

Data rate increasing method using multiple PN sequences for the superposed PNs on broadcasting system signals

机译:使用多个PN序列的数据速率增加方法在广播系统信号上使用多个PN序列

获取原文

摘要

For some additional data rate keeping backward compatibility, PN sequences can be good candidates. Because a PN sequence can be detected relatively with a small magnitude in low signal to noise ratio, it is advantageous to reduce their influences on the existing system signal. Conventionally PN sequences can be used to transmit modulation parameters for a hierarchically modulated T-DMB system and TxID information in ATSC 8-VSB digital TV. In this paper, we propose a method to increase data rates by mapping PN sequences to order-n QAM constellations. Thus each PN sequence transmits the same number of bits with order-n QAM modulation. Therefore, the data rates obtained by PN sequence mapping can be increased very much compared with the conventional PN sequence detection method.
机译:对于一些额外的数据速率,保持向后兼容性,PN序列可以是良好的候选者。因为可以在低信噪比中具有小幅度的幅度较小的PN序列,所以有利于降低它们对现有系统信号的影响。传统上,PN序列可用于在ATSC 8-VSB数字电视中发送用于分层调制的T-DMB系统的调制参数和TxID信息。在本文中,我们提出了一种通过将PN序列映射到Order-N QAM星座来提高数据速率的方法。因此,每个PN序列通过订单-N QAM调制发送相同数量的比特。因此,与传统的PN序列检测方法相比,通过PN序列映射获得的数据速率可以很多增加。

著录项

获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号