首页> 外文会议>International Conference on Engineering, Science and Technology >Sodium tripolyphosphate cross-linked chitosan based sensor for enhacing sensing properties towards acetone
【24h】

Sodium tripolyphosphate cross-linked chitosan based sensor for enhacing sensing properties towards acetone

机译:三聚磷酸钠交联壳聚糖基传感器,用于增强对丙酮的感测性能

获取原文

摘要

In this report, sensing properties of sodium tripolyphosphate (TPP) cross-linked chitosan based sensor has been successfully enhanced towards acetone. Chitosan solutions were cross-linked with sodium TPP in variation of 0.1%, 0.5%, 1% and 1.5% w/v, respectively. The sensors were fabricated in film form using an electrochemical deposition method. The sensing properties of the sensors were observed by exposing the pure chitosan and sodium TPP cross-linked chitosan sensors towards acetone concentrations of 5, 10, 50, 100 and 200 ppm. The measurement results revealed that the maximum response in output voltage value of pure chitosan sensor was 0.35 V while sodium TPP crosslinked chitosan sensors were above 0.35 V towards 5 ppm acetone concentration. When the sensors were exposed towards acetone concentration of 200 ppm, the maximum response of pure chitosan was 0.45 V while sodium TPP crosslinked chitosan sensors were above 0.45 V. Amongst the variation of sodium TPP, the maximum response of 1% sodium TPP was the highest since the maximum response was 0.4 V and 0.6 V towards 5 ppm and 200 ppm acetone concentration, respectively. While the maximum responses of other sodium TPP concentrations were under 0.4 V and 0.6 V towards 5 ppm and 200 ppm acetone concentration. Moreover, 1% sodium TPP cross-linked chitosan based sensor showed good reproducibility and outstanding lifetime. Therefore, 1% sodium TPP cross-linked chitosan based sensor has exhibited remarkable sensing properties as a novel acetone sensor.
机译:在本报告中,已经成功增强了三聚磷酸钠(TPP)交联壳聚糖的传感基于丙酮的感测性质。壳聚糖溶液分别与TPP的钠分别与0.1%,0.5%,1%和1.5%w / v交联。使用电化学沉积方法以薄膜形式制造传感器。通过将纯壳聚糖和TPP交联壳聚糖传感器暴露于丙酮浓度为5,10,50,100和200ppm来观察传感器的感测性能。测量结果表明,纯壳聚糖传感器的输出电压值的最大响应为0.35V,而TPP交联壳聚糖传感器高于0.35V至5ppm丙酮浓度。当传感器暴露于丙酮浓度200ppm时,纯壳聚糖的最大响应为0.45V,而TPP交联壳聚糖传感器高于0.45V。在TPP的变化中,1%TPP的最大反应是最高的由于最大响应为0.4V至0.6V至5ppm和200ppm丙酮浓度。虽然其他TPP浓度的最大反应率为0.4V和0.6V至5ppm和200ppm丙酮浓度。此外,1%TPP交联壳聚糖的传感器显示出良好的再现性和卓越的寿命。因此,1%TPP交联壳聚糖基的传感器具有作为新型丙酮传感器的显着感测性能。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号