首页> 外文会议>International topical meeting on nuclear reactor thermal hydraulics >WALL SUPERHEAT PREDICTION IN NARROW RECTANGULAR CHANNELS UNDER FULLY DEVELOPED BOILING OF WATER AT LOW PRESSURES
【24h】

WALL SUPERHEAT PREDICTION IN NARROW RECTANGULAR CHANNELS UNDER FULLY DEVELOPED BOILING OF WATER AT LOW PRESSURES

机译:低压全开水条件下窄矩形通道内壁过热的预测

获取原文

摘要

The modeling of two-phase heat transfer is a crucial issue in the safety analysis of nuclear reactors. The thermal-hydraulic correlations employed in this kind of simulations are usually derived from experiments that were carried out over limited ranges of parameters and for specific geometries. Therefore their applicability to systems with different characteristics has to be carefully scrutinized. In this paper, an assessment study of wall superheat correlations under fully developed boiling is presented. This is a contribution to the validation and improvement of the thermal-hydraulic modeling of the Jules Horowitz Reactor, which is a research reactor under construction at CEA-Cadarache (France). The SULTAN-JHR experiments are used. These tests were performed at CEA-Grenoble with upward water flow in a vertical uniformly heated narrow rectangular channel with gap of 2.16 mm. The experimental conditions ranged between 0.2 and 0.9 MPa for the pressure and between 0.5 and 4.4 MW/m~2 for the heat flux. It is shown that the correlations of Thorn and Jens-Lottes significantly overestimate the wall superheat. The correlation of Belhadj and Qiu, which were developed for narrow channels at low heat fluxes, cannot accurately predict the experimental data. On the other hand, satisfactory results can be obtained with Gorenflo (standard deviation of 11.9%) and a simplified version of the Forster-Greif (standard deviation of 10.1%) correlations. In conclusion, considering the validity range of the above correlations along with the outcomes of the current assessment, the simplified Forster-Greif correlation is thus recommended for the analysis of the JHR.
机译:在核反应堆的安全分析中,两相传热的建模是至关重要的问题。在这种模拟中采用的热工水力相关性通常来自在有限的参数范围内和针对特定几何形状进行的实验。因此,必须仔细检查它们对具有不同特性的系统的适用性。本文提出了在充分发展的沸腾条件下壁过热相关性的评估研究。这有助于验证和改进Jules Horowitz反应堆的热工液压模型,该反应堆是CEA-Cadarache(法国)在建的研究堆。使用了SULTAN-JHR实验。这些测试是在CEA-格勒诺布尔(CEA-Grenoble)上进行的,该水在间隙为2.16 mm的垂直均匀加热的狭窄矩形通道中向上流动。实验条件的压力范围为0.2至0.9 MPa,热通量的范围为0.5至4.4 MW / m〜2。结果表明,Thorn和Jens-Lottes的相关性显着高估了壁的过热度。 Belhadj和Qiu的相关性是为低热通量的狭窄通道开发的,无法准确预测实验数据。另一方面,使用Gorenflo(标准偏差为11.9%)和简化版的Forster-Greif(标准偏差为10.1%)相关性可以获得满意的结果。总之,考虑到上述相关性的有效性范围以及当前评估的结果,因此建议简化的Forster-Greif相关性用于JHR的分析。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号