首页> 外文会议>Conference on extreme ultraviolet lithography VI >Negative-tone imaging with EUV exposure for 14 nm hp and beyond
【24h】

Negative-tone imaging with EUV exposure for 14 nm hp and beyond

机译:负色成像,EUV曝光达到14 nm hp或更高

获取原文

摘要

Manipulation of dissolution properties by changing organic solvent developer and rinse material provides a novel technology to obtain fine pattern beyond the limitation of imaging system based on alkaline developer. QCM study showed no swelling character in negative-tone imaging (NTI) process even for current developer of n-butyl acetate (nBA). Actually, NTI process has shown advantages on resolution and line-width roughness (LWR) in loose pitch around 30 ~ 45 nm hp as a consequence of its non-swelling character. On the other hand, bridge and collapse limited its resolution below 20 nm hp, indicating that non-negligible amount of swelling still exists for tight pitch resolution. We investigated effects of solubility parameter of organic solvents on resolution below 20 nm hp. A bridge was reduced with a decrease in the solubility parameter 8p from nBA. On the other hand, much lower 8p caused film remaining due to its extremely slow Rmax. Based on these results, we newly developed FN-DP301 containing organic solvent with smaller 5p than nBA. Although rinse solvent gave negligible effects on bridge, there is a clear improvement on pattern collapse only in case of using new rinse solvent of FN-RP311. Lithographic performances of NTI process using nBA and FN-DP301 together with the other organic solvents were described in this paper under exposures with an E-beam and a EUV light. It is emphasized that 14 nm hp resolution was obtained only using FN-DP301 as a developer and FN-RP311 as a rinse under E-beam exposure. NTI showed 43% faster photospeed in comparison with PTI at 16 nm hp, indicating that NTI is applicable to obtain high throughput with maintaining resolution. In addition, sub-20 nm trench was obtained using NTI without bridge under EUV exposure, all of which are attributed to the low swelling character of NTI process. Similarly, NTI was able to print 20 nm dots using NXE:3100 with only a little peeling. Conversely CH patterning was significantly worse with NTI compared to PTI, that is, only 36 nm contacts with 60 nm pitch was resolved under EUV exposure.
机译:通过改变有机溶剂显影剂和冲洗材料来控制溶解性能,提供了一种新颖的技术来获得精细图案,这超出了基于碱性显影剂的成像系统的限制。 QCM研究表明,即使对于目前的醋酸正丁酯(nBA)显影剂,在负像成像(NTI)过程中也没有膨胀特性。实际上,由于NTI工艺具有非膨胀特性,因此在30〜45 nm hp左右的小间距上显示出了分辨率和线宽粗糙度(LWR)方面的优势。另一方面,桥接和塌陷将其分辨率限制在20 nm hp以下,这表明对于紧密的间距分辨率,仍然存在不可忽略的膨胀量。我们研究了有机溶剂的溶解度参数对低于20 nm hp的分辨率的影响。桥的减少是由于nBA的溶解度参数降低了8p。另一方面,低得多的8p由于极慢的Rmax而导致薄膜残留。根据这些结果,我们新开发了含有比nBA小5p的有机溶剂的FN-DP301。尽管漂洗溶剂对桥的影响可忽略不计,但只有在使用新的FN-RP311漂洗溶剂的情况下,图案塌陷才有明显的改善。本文介绍了使用nBA和FN-DP301以及其他有机溶剂进行的NTI工艺的光刻性能,该工艺在电子束和EUV灯下曝光。要强调的是,仅使用FN-DP301作为显影剂,使用FN-RP311作为冲洗剂在电子束曝光下才能获得14 nm hp分辨率。与16 nm hp的PTI相比,NTI的光速提高了43%,这表明NTI适用于在保持分辨率的情况下获得高通量。另外,使用NTI在EUV曝光下使用无桥获得了低于20 nm的沟槽,所有这些都归因于NTI工艺的低溶胀特性。同样,NTI能够使用NXE:3100进行20 nm点的打印,而只需一点剥离即可。相反,与PTI相比,NTI的CH图案明显更差,也就是说,在EUV曝光下,只有36 nm间距为60 nm的触点被分辨。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号