首页> 外文会议>IEEE Topical Conference on Power Amplifiers for Wireless and Radio Applications >A pulsed load modulation (PLM) power amplifier with 3-level envelope delta-sigma modulation (EDSM)
【24h】

A pulsed load modulation (PLM) power amplifier with 3-level envelope delta-sigma modulation (EDSM)

机译:具有3级包络delta-sigma调制(EDSM)的脉冲负载调制(PLM)功率放大器

获取原文

摘要

An X-band power amplifier (PA) based on the pulsed load modulation (PLM) architecture is developed. The PLM technique leverages on the load modulation characteristics incurred for modulated pulses with different duty cycles as the consequence of the interactions between switching PAs with the high-Q output filter. Though a high drain efficiency is promised by the PLM amplifier with a binary envelop input, the low coding efficiency of the 2-level pulse modulations including the 2-level Envelope Delta- Sigma Modulation (EDSM) reduces the effective gain of the PA and thus decreases the overall power added efficiency. The great amount of quantization noise also needs to be rejected with high-Q filter which adds a great burden to the output filter design. In this paper, it is proposed to feed the PLM PA with a 3-level EDSM signal for input with higher effective gain and lower quantization noise. The concept is demonstrated with an X-band PLM PA fabricated with discrete 0.25μm GaN HEMT. The proposed transmitter delivered 35.6 dBm output power with 40.5 % drain efficiency for 5 MHz WCDMA signal with 5.3 peak-toaverage ratio at 9.2 GHz.
机译:开发了基于脉冲负载调制(PLM)架构的X波段功率放大器(PA)。由于开关PA与高Q输出滤波器之间的相互作用,PLM技术利用了具有不同占空比的调制脉冲所产生的负载调制特性。尽管具有二进制包络输入的PLM放大器有望实现高漏极效率,但是2级脉冲调制(包括2级包络Delta-Sigma调制(EDSM))的低编码效率会降低PA的有效增益,因此降低了整体功率附加效率。高Q滤波器也需要消除大量的量化噪声,这给输出滤波器的设计增加了很大的负担。在本文中,建议以3级EDSM信号为PLM PA馈电,以使其具有更高的有效增益和更低的量化噪声。 X波段PLM PA由离散的0.25μmGaN HEMT制成,证明了这一概念。对于5 MHz WCDMA信号,建议的发射器在9.2 GHz时具有5.3峰均比,可提供35.6 dBm输出功率和40.5%的漏极效率。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号