DISPLACEMENT CONTROLLED STRESS INTENSITY FACTOR SOLUTIONS FOR STRUCTURAL INTEGRITY ASSESSMENTS OF WELDING RESIDUAL STRESS DISTRIBUTIONS

摘要

Within the UK nuclear industry the assessment of fracture in pressurised components is often carried out using procedures to calculate the margin of safety between a lower-bound fracture toughness and the crack driving force. Determination of the crack driving force usually requires the calculation of elastic stress intensity factor solutions for primary loads and secondary loads arising from weld residual stresses and/or thermal stresses. Within established UK assessment procedures weight function solutions are available which allow the stress intensity factors to be calculated from the through-wall opening-mode stress distribution in an uncracked component. These weight-function solutions are generally based on models where either no boundary condition is applied, or where one is applied at a distance either side of the crack plane that is very long compared with the crack size and wall thickness. Such solutions do not take into account any reduction in the stress field that might occur as the distance from the crack faces increases. Weld residual stress fields may often be expected to reduce in this manner.A separate, earlier study has shown that the stress intensity factor for a cracked plate loaded in displacement control decreases substantially as the loading plane is moved closer to the crack plane. It would therefore be expected that a similar reduction in stress intensity factor would be obtained for a residual stress analysis when displacement boundary conditions are imposed at a distance relatively close to the crack plane.This paper describes an investigation of the differences, particularly in terms of a reduction in calculated stress intensity factor, which may arise from application of displacement controlled stress intensity factor solutions, as compared with load controlled solutions, when considering weld residual stresses. Consideration is also given as to how new displacement controlled stress intensity factor solutions could be developed by modification of existing load controlled solutions.