Configuration, Fabrication, and Installation of Tahiti Truss Spar Belly Strakes

摘要

Two types of Vortex Induced Motion (VIM) suppression strakes were used on the Tahiti Truss Spar: yard installed strakes which were fabricated and installed in the shipyard and the field installed strakes, referred to as belly strakes. The belly side strakes were fabricated in the shipyard, but installed offshore after the hull upending and fixed ballast installation. Yard installation was not possible due to interference with the transportation arrangement. The major components of the belly strake system are as follows: Sleeves which are installed in the spar hull in the yard and serve as receptacles for the support pins, support pins which are swaged into the sleeves using the patented Oil States Inc. (OSI) Hydra-Lok? tool. The support pins serve as structural support members for the Belly Strake panels. Belly strake panels are approximately 20 ft wide and ranging from 15 ft long to 50 ft long. Panel lengths were optimized to achieve similar loading for each of the support pin to sleeve connection. Each strake panel was set onto its corresponding two support pins and is connected via a bolted connection. This paper describes the methods used for fabrication and installation of the Tahiti belly strake components. The fabrication methodology is outlined, including a detailed description of the belly strake system, the component fit-up, and the integration testing methods. Offshore installation of the belly side strakes is described, including the structural connections formed between the components. The installation was performed with on-hull installation aids and installation tools specifically designed for the belly strake installation. A detailed description of the installation aids and their functions is presented, together with the installation steps performed offshore.