【24h】

The Effects of Additives on Yields and Distribution of Gasand Liquid from Pyrolysis of Biomass by Microwave Heating

机译:微波加热生物质热解过程中添加剂对气体和液体产率和分布的影响

获取原文

摘要

Pyrolysis of pine wood sawdust was carried out by microwave heating at ca.470°C under dynamic nitrogen atmosphere. Eight inorganic additives(NaOH,Na2CO3,Na2SiO3,NaCl,TiO2.HZSM-5,H3PO4.Fe2(SO4)3)were investigated in terms of their catalytic eriects on the pyrolysis.All of the eight additives have increased yields of solid products greatly and decreased yields of gaseous products more or less.Yields of liquid products have not subjected to dramatic change.The incondensable gases produced from pyrolysis consist mainly of H2,CH4,CO and CO2.All of the eight additives have made these gases evolve earlier,among which the four sodium additives have the most marked effect.All the additives have made the amount of CH4 and CO2 decrease,while all of them except NaCl,TiO2 and Fe,(SO4)3 have made that of H2 increase and all of them except Na2SiO3 and HZSM-5 have made that of CO decrease.Alkaline sodium compounds NaOH, Na2CO3 and Na2SiO3 favor H2 formation most.The most abundant organic component in the liquid products from pyrolysis of untreated sample and samples treated by all the additives except H3PO4 and Fe2(SO4)3 is acetol.All the four sodium compounds favor acetol formation reaction and the selection increasing effect follows the order of NaOH> Na2CO3≈Na2SiO3>NaCl.TiO2 goes against the formation of acetol,HZSM-5 has no marked effect on acetol formation. The two dominant organic components identified in the liquid products from pyrolysis of H3PO4 and Fe2(SO4)3 treated samples are both fufural and 4-methyl-2-methoxy-phenol.Organic composition of liquid products from the microwave pyrolysis of sawdust in this study is quite different from that by conventional heating and the underlying causes forming this difference is tentatively proposed.
机译:松木锯末的热解是在动态氮气氛下,在约470°C下通过微波加热进行的。研究了8种无机助剂的热裂解催化性能,分别为NaOH,Na2CO3,Na2SiO3,NaCl,TiO2.HZSM-5,H3PO4.Fe2(SO4)3。这8种助剂均大大提高了固体产物的收率。热解产生的不凝气体主要由H2,CH4,CO和CO2组成。八种添加剂都使这些气体较早地析出,并且气态产物的收率或多或少地降低了。其中四种钠添加剂效果最为显着。所有添加剂均降低了CH4和CO2的含量,除NaCl,TiO2和Fe,(SO4)3以外均使H2的含量增加,而所有这些添加剂均使H2的含量增加。除Na2SiO3和HZSM-5外,CO均降低。碱性钠化合物NaOH,Na2CO3和Na2SiO3最有利于H2的形成。未经处理的样品和经除H3PO4和H2O3外的所有添加剂处理的样品的热解,液体产物中最丰富的有机成分。铁2(SO4)3为丙酮醇。四种钠化合物均促进丙酮醇的生成反应,其选择增加的作用依次为NaOH>Na2CO3≈Na2SiO3>NaCl。TiO2不利于丙酮醇的生成,HZSM-5对丙酮醇没有明显的影响。丙酮醇的形成。经H3PO4和Fe2(SO4)3处理的样品热解的液体产物中鉴定出的两个主要有机成分是果糖和4-甲基-2-甲氧基苯酚。与常规加热的情况完全不同,并初步提出了形成这种差异的根本原因。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号