Characterization of a GEM-3 array for UXO classification

摘要

We have designed and built a non-synchronous, sequential array of GEM-3 sensors for use with the Multi-sensor Towed Array Detection System (MTADS) with support from ESTCP. The roughly 2-m square array consists of three, 96-cm diameter GEM-3 s in a triangular configuration. The GEM drive electronics have been modified to produce a substantially higher transmit moment, and thus increased sensitivity, than the standard GEM-3. The individual sensors transmit a composite waveform made up of ten frequencies from 30 Hz to 48 kHz for a single 1/30 s base period, Sequential operation allows two of these base periods for deconvolution and output of the frequency-dependent response from each GEM-3. After allowing for a short coil settling time between sensors, we achieve an array sampling rate of just over 9 Hz. Coupled with our standard survey speed of 3 mph, this results in a down-track sampling spacing of ～15 cm. The cross-track spacing is 50 cm. We have characterized these sensors at our Blossom Point test site. The static and dynamic response of the array to a variety of ordnance, ordnance simulants, and scrap is presented with consideration given to both detection and classification.