首页> 外文会议> >A Pseudo-Raised Cosine IR-UWB pulse generator with adaptive PSD using 130nm CMOS process
【24h】

A Pseudo-Raised Cosine IR-UWB pulse generator with adaptive PSD using 130nm CMOS process

机译:使用130nm CMOS工艺的具有自适应PSD的伪升余弦IR-UWB脉冲发生器

获取原文

摘要

This paper presents the design of a Pseudo-Raised Cosine Impulse Radio Ultra-Wide Band (IR-UWB) pulse generator with adaptive PSD (Power Spectrum Density) that produces pulse shaping just altering the number of oscillations and amplitude. The complete pulse generator circuit is composed of 11 blocks of edge combiner stages implemented with high impedance circuits each, a digital control block, and a filter. This circuit can generate from four to eleven oscillations per clock edge to compose a PRC (Pseudo-Raised Cosine) at the output. The proposed circuit operates at about 10.3 GHz and generates three basic pulses, with a range of 10, 20 and 30 mV and four other amplitude combinations. The post-layout simulations were performed using the Cadence Spectrum/Virtuoso, and the dynamic energy varied from 5.02 fJ with four oscillations to 16.11 fJ with eleven oscillations per pulse, respectively. Thus, the maximum PSD peak is −60 dBm, the minimum is −72 dBm with a voltage supply of 1.2 V. Finally, the Pulse Repetition Frequency (PRF) of 100 MHz and the size of the main chip occupies an area of 0.042 mm2 (without pads).
机译:本文介绍了具有自适应PSD(功率谱密度)的伪升余弦脉冲无线电超宽带(IR-UWB)脉冲发生器的设计,该发生器仅改变振荡次数和幅度即可产生脉冲整形。完整的脉冲发生器电路由11个边缘组合器级模块组成,每个模块均由高阻抗电路,数字控制模块和滤波器组成。该电路可以在每个时钟沿产生4到11个振荡,以在输出端构成PRC(伪升余弦)。拟议中的电路工作在大约10.3 GHz,并产生三个基本脉冲,范围分别为10、20和30 mV,以及四个其他幅度组合。使用Cadence Spectrum / Virtuoso进行布局后仿真,动态能量分别从5.02 fJ(四个振荡)到16.11fJ(每个脉冲十一个振荡)变化。因此,在1.2 V电源电压下,最大PSD峰值为-60 dBm,最小为-72 dBm。最后,脉冲重复频率(PRF)为100 MHz,主芯片尺寸为0.042 mm2 (不含护垫)。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号