首页> 外文会议>International conference on modelling, monitoring and management of air pollution >ANALYSIS OF AIR POLLUTANT EMISSIONS IN A WASTEWATER TREATMENT PLANT USING DISPERSION MODELS
【24h】

ANALYSIS OF AIR POLLUTANT EMISSIONS IN A WASTEWATER TREATMENT PLANT USING DISPERSION MODELS

机译:分散模型污水处理厂空气污染物排放分析

获取原文

摘要

The dispersion of air pollutants such as Ammonia (NH_3) and Hydrogen Sulphide (H_2S) emitted by a municipal wastewater treatment plant (WWTP) was studied for a period of over one year. The main intent was to support the environmental impact assessment focusing on the diffusion of annoying odours over surrounding areas during the regular activity of the sewage treatment facility. The adopted methodology consists in comparing, in three test cases, the performance of the Gaussian plume model AERMOD, an American Meteorological Society and U.S. Environmental Protection Agency Regulatory Model, against the performance of the 3-D Lagrangian model AUSTAL2000, a German Dispersion Model developed according to the Technical Instructions on Air Quality Control. Both models were run over a domain of about 30km~2 made of hilly zones and located in the centre-eastern Italy. Ten sources of airborne pollutants, located along the sludge treatment line and considered as area sources, were taken into account. The diffuse emissions associated with odour production within WWTP were estimated considering the pollutant emission factors suggested by the American Environmental Protection Agency (EPA). The test cases included different emission scenarios deriving from three different operative plant configurations set in order to investigate the most impacting one. The results show a good agreement between the two model outputs since the annual average for NH_3 and H_2S are almost equivalent. These concentrations are below the legal limits while the highest values, measured at closest receptors, are beneath the odour perceptibility thresholds. Some noteworthy differences concern the AERMOD distribution maps that show a sort of pollutant stagnation over complex topography areas, especially in valleys, and a farer allocation of the highest pollutants levels from the source, while the AUSTAL2000 model is more biased to distribute the highest values closer to the sources.
机译:在城市废水处理厂(WWTP)发出的氨(NH_3)和硫化氢(H_2S)之类的空气污染物(WWTP)的分散在一年多的时间内。主要目的是支持环境影响评估,重点是在污水处理设施的定期活动期间在周围地区的恼人气味扩散。采用的方法包括比较,在三个测试用例中,在三斯羽毛模型Aermod,美国气象社会和美国环保局监管模式的表现,反对表现为3-D拉格朗日模型Austal2000,是德国分散模型的开发根据空气质量控制的技术指示。这两种模型都在一个大约30km〜2的领域运行,由丘陵区制成,位于意大利东部。考虑到沿着污泥处理线并被视为区域来源的十个空气污染物来源。考虑到美国环境保护局(EPA)建议的污染物排放因素,估计与WWTP内的气味生产相关的漫反射排放。测试用例包括源自三种不同的操作植物配置的不同发射方案,以便调查最大的影响。由于NH_3和H_2S的年平均值几乎等效,因此结果显示了两个模型输出之间的良好一致性。这些浓度低于法律限制,而在最近的受体中测量的最高值是在气味可感性阈值下方。一些值得注意的差异涉及Aermod分布地图,显示出在复杂地形区域,特别是山谷的污染物滞后,以及来自源的最高污染物水平的更票分配,而Austal2000模型更偏置以分配更近的最高值到来源。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号