首页> 外文会议>International conference on smart materials and nanotechnology in engineering >TEM study of pre-strain's effect on shape recovery character in an Fe-Mn-Si-Cr-Ni shape memory alloy
【24h】

TEM study of pre-strain's effect on shape recovery character in an Fe-Mn-Si-Cr-Ni shape memory alloy

机译:TEM对Fe-Mn-Si-Cr-Ni形状记忆合金中应变恢复特性的影响的TEM研究

获取原文

摘要

Relationship between amount of recoverable strain and pre-strain in Fe-25%Mn-4.5%Si-1%Cr-2%Ni shape memory alloy (SMA) was measured in tensile tests. The results show that recoverable strain increases with increasing pre-strain lower than 5%, and decreases rapidly when the pre-strain go beyond 5%. By X-ray diffraction, the effect of pre-strain on volume fraction of stress induced ε martensite (eM) was determined and it was found that amount of eM first keeps increasing with pre-strain and then reaches saturation when pre-strain is over 8%. Transmission electron microscope (TEM) observation shows that morphology of stress induced eM for different pre-strain differs greatly and thus has different influence on shape memory effect (SME) of the alloy. Three types of morphology of εM were observed for different pre-strain, which are thin eM plates, wide eM bands of multilayer and intersecting eM variants respectively.
机译:在拉伸试验中测量了Fe-25%Mn-4.5%Si-1%Cr-2%Ni形状记忆合金(SMA)中可恢复应变量与预应变之间的关系。结果表明,可恢复应变随着预应变的增加低于5%而增加,而当预应变超过5%时可恢复应变迅速下降。通过X射线衍射,确定了预应变对应力诱发ε马氏体(eM)体积分数的影响,发现随着预应变的增加,eM的数量先保持增加,然后达到饱和。 8%。透射电子显微镜(TEM)观察表明,不同预应变的应力诱导eM的形貌差异很大,因此对合金的形状记忆效应(SME)的影响也不同。对于不同的预应变,观察到三种类型的εM形态,分别是薄的eM板,宽的多层eM带和相交的eM变体。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号