首页> 外文会议>International Conference on Renewable Power Generation >Research on the reactive power control of wind turbines and dynamic reactive compensation equipment in high-voltage trip-off accident
【24h】

Research on the reactive power control of wind turbines and dynamic reactive compensation equipment in high-voltage trip-off accident

机译:高压跳闸事故中风机及无功动态补偿设备的无功控制研究

获取原文
获取原文并翻译 | 示例

摘要

This paper proposed an explanation on a special phenomenon of voltage change during a large-scale trip-off accident of wind turbine generators (WTGs), which occurred in North China on May 14, 2012. In this accident, the local voltage rose slowly from 209kV to 242kV in 5 seconds after a small-capacity capacitor was switched on. As a result, hundreds of WTGs tripped off due to high voltage. The slow rising process of voltage in this accident is remarkably different from the common feature of voltage change under capacitor switching disturbances. Firstly, the main process of this high voltage trip-off accident is analysed, and the correlation between the change of active power/reactive power and the rise in voltage is discussed. It can be drawn that the voltage rising process was mainly because of the change of reactive power. Secondly, a model of wind-integrated power system is built in DIgSILENT/ PowerFactory. The impact of reactive power control mode of doubly fed induction generators (DFIGs) and static var generators (SVGs) on the voltage change are simulated. The simulation results indicate that both SVGs and DFIGs in constant reactive power control mode can lead to a slow rise in voltage. Furthermore, it is demonstrated that the rise rate of voltage depends on the dynamic response time of WTGs and dynamic reactive compensation equipment. In consideration of the low operation ratio of dynamic reactive compensation equipment at that time, the main reason of this high-voltage trip-off accident is WTGs worked in constant power control mode.
机译:本文针对2012年5月14日在华北发生的大型风力发电机的跳闸事故中的一种特殊的电压变化现象做出了解释。在该事故中,本地电压从接通小容量电容器后的5秒钟内,从209kV变为242kV。结果,数百个WTG由于高压而跳闸。在此事故中,电压的缓慢上升过程与电容器切换扰动下电压变化的共同特征明显不同。首先,分析了该高电压跳闸事故的主要过程,讨论了有功功率/无功功率变化与电压上升之间的关系。可以看出,升压过程主要是由于无功功率的变化。其次,在DIgSILENT / PowerFactory中建立了风力发电系统模型。模拟了双馈感应发电机(DFIG)和静态无功发电机(SVG)的无功功率控制模式对电压变化的影响。仿真结果表明,恒定无功功率控制模式下的SVG和DFIG均可导致电压缓慢上升。此外,证明了电压的上升速率取决于WTG和动态无功补偿设备的动态响应时间。考虑到当时动态无功补偿设备的低运行率,造成这种高电压跳闸事故的主要原因是在恒定功率控制模式下工作的WTG。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号