Single-Polarization Optical Low-Noise Pre-Amplified Receiver for Heavily Coded Optical Communications Links

摘要

We report a single-polarization, optical low-noise pre-amplifier (SP-OLNA) that enhances the receiver sensitivity of heavily-coded 1.55-μm optical communication links. At channel bit-error ratios of approximately 10%, the erbium-doped SP-OLNA provides an approximately 1.0-dB receiver sensitivity enhancement over a conventional two-polarization pre-amplifier. The SP-OLNA includes three gain stages, each followed by narrow-band athermal fiber Bragg gratings. This cascaded filter is matched to a return-to-zero, 2.88-Gb/s, variable burst-mode, differential phase shift keying (DPSK) waveform. The SP-OLNA enhancement of approximately 1.0 dB is demonstrated over a range of data rates, from the full 2.88-Gb/s (non-burst) data rate, down to a 1/40th burst rate (72 Mb/s). The SP-OLNA's first stage of amplification is a single-polarization gain block constructed from polarization-maintaining (PM) fiber components, PM erbium gain fiber, and a PM integrated pump coupler and polarizer. This first stage sets the SP-OLNA's noise figure, measured at 3.4 dB. Two subsequent non-PM gain stages allow the SP-OLNA to provide an overall gain of 78 dB to drive a DPSK demodulator receiver. This receiver is comprised of a delay-line interferometer and balanced photo-receiver. The SP-OLNA is packaged into a compact, 5"×7"×1.6" volume, which includes an electronic digital interface to control and monitor pump lasers, optical switches, and power monitors.