首页> 外文会议>US Combustion Meeting; 20070325-28; San Diego,CA(US) >An Experimental and Theoretical Approach to Soot Particle Inception in Laminar Diffusion Flames
【24h】

An Experimental and Theoretical Approach to Soot Particle Inception in Laminar Diffusion Flames

机译:层流扩散火焰中烟尘颗粒形成的实验和理论方法

获取原文
获取原文并翻译 | 示例

摘要

For diffusion flames, the combination of oxygen enrichment and fuel dilution results in an increase in the stoichiometric mixture fraction, Z_(st), and alters the flame structure, i.e. the relationship between the local temperature and the local gas composition. Increasing Z_(st) has been shown to result in the reduction or even elimination of soot formation in traditional laboratory flames. In the present work, the effects of variable Z_(st) on soot inception is investigated in normal and inverse coflow flames, using ethylene as the fuel. Use of the inverse coflow flame underscores the validity of these concepts since, unlike the normal configuration, the convective field in the inverse flame directs particles into a fuel rich region rather than an oxidizer rich region. Sooting limits based on particle luminosity are measured as a function of Z_(st).The sooting limit is obtained by varying the amount of inert gas until soot appears above a predefined height. For each limit flame, the adiabatic flame temperature is calculated based on equilibrium and defined hereafter as the limit flame temperature. The limit flame temperature is found to increase linearly with Z_(st), for both normal and inverse flames. The effects of residence time are also investigated, and the soot inception temperature is found to be dependent on fuel stream velocity for both the normal and inverse configuration. A simple model is presented which describes how increasing Z_(st) results in the reduction and ultimately elimination of soot. This model assumes that soot inception can only occur in a region where critical values for species, temperature, and residence time are met. The soot inception region is bounded on the low temperature side by a critical temperature which is a function of residence time, and on the high temperature side by a second critical temperature which is a function of the critical local carbon to oxygen ratio. The effect of increasing Z_(st) is to move the boundaries of the soot inception zone towards each other, until the zone is infinitely thin and the sooting limit is reached. By utilizing the model with experimental data, it is suggested that the critical local C/O ratio for soot inception in nonpremixed flame is similar to the global critical C/O ratio associated with premixed flames. Finally, the model is shown to accurately predict sooting limits as a function of Z_(st) in coflow diffusion flames based only on fundamental properties of the reactants.
机译:对于扩散火焰,氧气富集和燃料稀释的结合导致化学计量混合物分数Z_(st)的增加,并改变了火焰结构,即局部温度和局部气体成分之间的关​​系。 Z_(st)的增加已表明可以减少甚至消除传统实验室火焰中烟灰的形成。在当前的工作中,使用乙烯作为燃料,在正向和反向同向火焰中研究了变量Z_(st)对烟灰起始的影响。使用逆向同流火焰强调了这些概念的有效性,因为与正常配置不同,逆向火焰中的对流场将颗粒引导到燃料富集区域而不是氧化剂富集区域。根据Z_(st)来测量基于颗粒发光度的烟尘极限。烟尘极限是通过改变惰性气体的量直到烟灰出现在预定高度以上而获得的。对于每个极限火焰,根据平衡计算绝热火焰温度,并且在下文中将其定义为极限火焰温度。对于正向和反向火焰,极限火焰温度都随Z_(st)线性增加。还研究了停留时间的影响,发现在正常构型和相反构型下,烟灰起始温度都取决于燃料流的速度。提出了一个简单的模型,该模型描述了如何增加Z_(st)导致烟灰的减少并最终消除。该模型假设烟尘开始只能发生在满足物种,温度和停留时间的临界值的区域。烟灰起始区域在低温侧由作为停留时间的函数的临界温度界定,而在高温侧由第二临界温度(其是临界局部碳氧比的函数)界定。增大Z_(st)的作用是使烟灰起始区域的边界彼此相对移动,直到该区域无限薄并且达到了烟灰极限。通过利用具有实验数据的模型,建议在非预混火焰中烟灰起始的临界局部C / O比值与预混火焰相关的全局临界C / O比值相似。最后,仅基于反应物的基本特性,该模型显示出可精确预测烟灰极限随同流扩散火焰中Z_(st)的变化。

著录项

  • 来源
  • 会议地点 San DiegoCA(US)
  • 作者单位

    Department of Mechanical and Aerospace Engineering, Washington University in St.Louis, St. Louis, Missouri 63130, USA;

    Department of Land, Air and Water Resources, University of California, Davis, Davis, California 95616, USA;

  • 会议组织
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类 理论;
  • 关键词

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号