【24h】

THE WAKE OF TWO STAGGERED CIRCULAR CYLINDERS

机译:两个交错的圆柱的唤醒

获取原文
获取原文并翻译 | 示例

摘要

The work aims to study experimentally the flow structure, heat and momentum transport in the wake of two staggered circular cylinders. The cylinder center-to-center pitch ranged from 1.2 to 4.0, and the angle between the incident flow and the direction through the two cylinder axes was between 0° and 90°. In order to characterize the heat transport of this flow, both cylinders were slightly heated so that heat generated could be considered to be a passive scalar. The velocity and temperature fluctuations were measured using a movable three-wire (one X-wire plus a cold wire) probe across the wake and a fixed X-wire, which acted to provide a reference signal. Measurements were conducted at x/d= 10 and 20 and a Reynolds number of 7000, where d is the cylinder diameter and x is the longitudinal distance from the mid point between the cylinders. Based on phase-averaged vorticity contours and sectional streamlines, the flow structure behind two staggered cylinders is classified into five typical patterns. The flow behaviours for each pattern are examined in detail, including its topology, vortex strength, stability and decay rate. The different behaviours between the patterns are further linked to the different initial conditions. The momentum and heat transport are not presented due to limited space.
机译:这项工作旨在通过实验研究两个交错的圆柱体之后的流动结构,热量和动量传递。气缸的中心距为1.2到4.0,并且入射流和通过两个气缸轴的方向之间的夹角在0°和90°之间。为了表征该流的热传递,两个汽缸都被略微加热,因此产生的热量可以被认为是被动标量。速度和温度波动是通过可移动的三线(一根X线加一根冷线)探头在尾流和一条固定的X线进行测量的,X线起提供参考信号的作用。测量是在x / d = 10和20且雷诺数为7000的情况下进行的,其中d是圆柱直径,x是从圆柱之间的中点开始的纵向距离。基于相位平均涡度轮廓线和截面流线,将两个交错圆柱体后面的流动结构分为五个典型模式。详细检查了每种模式的流动行为,包括其拓扑,涡旋强度,稳定性和衰减率。模式之间的不同行为还与不同的初始条件相关。由于空间有限,没有显示动量和热传递。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号