首页> 外文会议>Advanced Communication Technology (ICACT), 2012 14th International Conference on >Wireless repeater with equalization of feedback channel and phase noise for LTE-Advanced uplink
【24h】

Wireless repeater with equalization of feedback channel and phase noise for LTE-Advanced uplink

机译:用于LTE-Advanced上行链路的均衡反馈信道和相位噪声的无线转发器

获取原文
获取原文并翻译 | 示例
获取外文期刊封面目录资料

摘要

When the gain of a wireless repeater is larger than the isolation between transmit and receive antennas of the repeater, the feedback signal that comes into the receive antenna from the transmit antenna of the repeater causes the repeater to go into feedback oscillation regardless of the input signal. In this paper, we propose adaptive equalizer and phase noise compensator in order to effectively cancel feedback channel and phase noise in wireless repeater system based on LTE-Advanced uplink system. In a repeater system, the performance has got worse caused by feedback channel and phase noise. Thus, the interference cancellation system requires to removing the interference signal in wireless repeater. In this paper, in order to cancel feedback channel, we use adaptive equalizer such as NLMS and RLS. And, in LTE-Advanced uplink standard, block type pilot is a common pilot pattern in wireless communication systems. So the phase noise compensator exploits block type pilot. Instead of estimating phase noise in other algorithms, which are pretty difficult and complex to get accurate estimation results, the proposed method directly estimates the interference components caused by phase noise and improves estimation accuracy. After that, we reconstruct the interference matrix and suppress the interferences by the inverse matrix method. BER performance of proposed method is satisfied 12.5dB at 10-4.
机译:当无线转发器的增益大于转发器的发射天线与接收天线之间的隔离度时,无论输入信号如何,从转发器的发射天线进入接收天线的反馈信号都会使转发器进入反馈振荡状态。在本文中,我们提出了自适应均衡器和相位噪声补偿器,以有效地消除基于LTE-Advanced上行链路系统的无线转发器系统中的反馈信道和相位噪声。在转发器系统中,由于反馈通道和相位噪声导致性能变差。因此,干扰消除系统需要去除无线转发器中的干扰信号。在本文中,为了消除反馈通道,我们使用了自适应均衡器,例如NLMS和RLS。并且,在高级LTE上行链路标准中,块类型导频是无线通信系统中的常见导频模式。因此,相位噪声补偿器利用了块状导频。代替了其他算法的相位噪声估计,要获得准确的估计结果是非常困难和复杂的,该方法可以直接估计由相位噪声引起的干扰分量,从而提高估计精度。此后,我们重建干扰矩阵并通过逆矩阵方法抑制干扰。所提方法的BER性能在10-4时可满足12.5dB。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号