【24h】

Improved Single-Stream Beamforming Algorithm in TD-LTE System

机译:TD-LTE系统中改进的单流波束成形算法

获取原文
获取原文并翻译 | 示例

摘要

Beam forming (BF) is a pre-signal processing technique used in sensor arrays for directional signal transmission or reception. It produces directional BF by adjusting the weighted coefficient of each array element to obtain obvious array gain. At present, the most common BF algorithms are eigen-based Beam firming (EBB) algorithm and grid of beam (GOB) algorithm, but these two algorithms still have some defects. Therefore, this paper thoroughly illustrates EBB and GOB algorithms and respectively presents the corresponding improvements. On the one hand, this article proposes a modified EBB algorithm which only adaptively changes phase pattern to reduce the impact on the amplitude of the original signal, thus decreases the power loss. On the other hand, this paper puts forward an improved GOB algorithm which adds the correlation factors of the antennas with different polarization at the same physical position to increase BF gain. The performances of improved and original BF algorithms are simulated in a platform of TD-LTE. The simulation result shows that BLER performances of two enhanced BF algorithms are better than corresponding traditional algorithms.
机译:波束成形(BF)是传感器阵列中用于定向信号传输或接收的信号预处理技术。它通过调整每个阵列元素的加权系数来产生定向BF,以获得明显的阵列增益。目前,最常用的BF算法是基于特征的波束固定(EBB)算法和波束网格(GOB)算法,但是这两种算法仍然存在一些缺陷。因此,本文全面阐述了EBB和GOB算法,并分别提出了相应的改进。一方面,本文提出了一种改进的EBB算法,该算法仅自适应地改变相位模式以减少对原始信号幅度的影响,从而降低了功率损耗。另一方面,提出了一种改进的GOB算法,该算法在相同的物理位置上增加了不同极化天线的相关因子,以提高BF增益。在TD-LTE平台上模拟了改进后的原始BF算法的性能。仿真结果表明,两种改进的BF算法的BLER性能均优于相应的传统算法。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号