...
【24h】

Pressure-temperature-time paths of sediment recycling beneath the Tonga-Kennadec arc

机译:汤加-肯纳德弧线下方泥沙循环的压力-温度-时间路径

获取原文
获取原文并翻译 | 示例
           

摘要

The fate of subducted sediment and the extent to which it is dehydrated and/or melted before incorporation into arc lavas has profound implications for the thermo-mechanical nature of the mantle wedge and models for crustal evolution. In order to address these issues, we have undertaken the first measurements of Be-10 and light elements in lavas from the Tonga-Kermadec arc and the sediment profile at DSDP site 204 outboard of the trench. The Be-10/Be-9 ratios in the Tonga lavas are lower than predicted from flux models but can be explained if (a) previously estimated sediment contributions are too high by a factor of 2-10, (b) the top 1-22 m of the incoming sediment is accreted, (c) large amounts of sediment erosion are proposed, or (d) the sediment component takes several Myr longer than the subducting plate to reach the magma source region beneath Tonga. The lavas form negative Th/Be-Li/Be arrays that extend from a depleted mantle source composition to lower Th/Be and Li/Be ratios than that of the bulk sediment. Thus, these arrays are not easily explained by bulk sediment addition and, using partition coefficients derived from experiments on the in-coming sediment, we show that they are also unlikely to result from fluid released during dehydration of the sediment (or altered oceanic crust). However, partial melts of the dehydrated sediment residue formed at similar to 800 degrees C during the breakdown of amphibole +/- plagioclase and in the absence of cordierite have significantly lowered Th/Be ratios. The lava arrays can be successfully modelled as 10-15% partial melts of depleted mantle after it has been enriched by the addition of 0.2-2% of these partial melts. Phase relations suggest that this requires that the top of the subducting crust reaches temperatures of similar to 800 degrees C by the time it attains similar to 80 km depth which is in excellent agreement with the results of recent numerical models incorporating a temperature-dependent mantle viscosity. Under these conditions the wet basalt solidus is also crossed yet there is no recognisable eclogitic signal in the lavas suggesting that on-going dehydration or strong thermal gradients in the upper part of the subducting plate inhibit partial melting of the altered oceanic crust. (c) 2005 Elsevier B.V. All rights reserved.
机译:俯冲沉积物的命运以及在结合入弧熔岩之前其脱水和/或融化的程度对地幔楔的热机械性质和地壳演化模型具有深远的意义。为了解决这些问题,我们对汤加-克马德茨弧中的熔岩中的Be-10和轻元素进行了首次测量,并测量了沟槽外侧DSDP站点204的沉积物剖面。汤加熔岩中的Be-10 / Be-9比率低于通量模型所预测的比率,但如果(a)先前估计的泥沙贡献过高2-10倍,(b)最高的1-积聚了22 m的进入沉积物,(c)提出了大量的沉积物侵蚀,或(d)沉积物成分比俯冲板要花费数Myr,才能到达汤加下方的岩浆源区。熔岩形成负的Th / Be-Li / Be阵列,从耗尽的地幔源组成延伸到Th / Be和Li / Be的比值低于散装沉积物的比例。因此,这些阵列不易通过大量沉积物的添加来解释,并且使用从对即将来临的沉积物进行实验得出的分配系数,我们表明,它们也不大可能是由于沉积物脱水(或改变的海洋地壳)过程中释放的流体而产生。然而,在闪石+/-斜长石分解过程中以及在没有堇青石的情况下,类似于800摄氏度形成的脱水沉积物残余物的部分熔体具有显着降低的Th / Be比。通过添加0.2-2%的贫化地幔,可将熔岩阵列成功建模为贫化地幔的10-15%的部分融化。相关系表明,这要求俯冲地壳的顶部在达到类似于80 km的深度时达到大约800摄氏度的温度,这与结合温度依赖地幔粘度的最新数值模型的结果非常吻合。在这些条件下,湿玄武岩固相线也穿过了,但是在熔岩中没有可识别的凝结信号,表明俯冲板上部正在进行的脱水或强烈的热梯度会抑制蚀变海洋表层的部分融化。 (c)2005 Elsevier B.V.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号