...
首页> 外文期刊>Applied optics >Pressure dependence of laser-induced fluorescence from acetone
【24h】

Pressure dependence of laser-induced fluorescence from acetone

机译:丙酮激光诱导的荧光的压力依赖性

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

The use of laser-induced fluorescence (LIF) from acetone is becoming increasingly widespread as a diagnostic of mixing processes in both reacting and nonreacting flows. One of the major reasons for its increasing use is that the acetone LIF signal is believed to be nearly independent of pressure because of fast intersystem crossing from the first excited singlet state, from which the fluorescence signal originates, to the first excited triplet state, which does not fluoresce. To evaluate the use of acetone LIF at pressures higher than atmospheric, we have performed a study of acetone LIF in a flowing gas cell at pressures up to 8 atm. We used four different buffer gases: air, nitrogen, methane, and helium. Surprisingly, we find that the acetone fluorescence quantum efficiency increases slightly (similar to 30%-50%) as the buffer-gas pressure increases from 0.6 to 5 atm for all four buffer gases. When the buffer gas is air, we observe a decrease in the acetone fluorescence quantum efficiency as the buffer-gas pressure is increased from 5 to 8 atm; for the other three buffer gases the quantum efficiency is constant to within experimental error in this pressure regime. The observed pressure dependence of the acetone fluorescence signal is explained by use of a four-level model. The increase in the fluorescence quantum efficiency with pressure is probably the result of incomplete vibrational relaxation coupled with an increase in the intersystem crossing rate with increasing vibrational excitation in the first excited singlet manifold. (C) 1997 Optical Society of America.
机译:来自丙酮的激光诱导荧光(LIF)的使用正越来越广泛地用于诊断反应流和非反应流中的混合过程。丙酮LIF信号被广泛使用的主要原因之一是,丙酮LIF信号被认为几乎与压力无关,这是因为从荧光信号所产生的第一个激发单重态到第一个激发三重态的快速系统间交叉。不发荧光。为了评估在高于大气压的压力下使用丙酮LIF的情况,我们对流动的气室中压力高达8 atm的丙酮LIF进行了研究。我们使用了四种不同的缓冲气体:空气,氮气,甲烷和氦气。出乎意料的是,我们发现,对于所有四种缓冲气体,当缓冲气体压力从0.6 atm增加到5 atm时,丙酮荧光量子效率会略有增加(大约30%-50%)。当缓冲气体为空气​​时,随着缓冲气体压力从5 atm增加到8 atm,丙酮荧光量子效率会降低;对于其他三种缓冲气体,在此压力范围内,量子效率恒定在实验误差范围内。通过使用四级模型解释了所观察到的丙酮荧光信号的压力依赖性。荧光量子效率随压力的增加可能是不完整的振动弛豫,以及随着第一激发单重态歧管中振动激发的增加,系统间交叉速率增加的结果。 (C)1997年美国眼镜学会。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号