Aeration to degas CO2, increase pH, and increase iron oxidation rates for efficient treatment of net alkaline mine drainage

摘要

Passive treatment systems for mine drainage use no energy other than gravity, but they require greater area than active treatment systems. Researchers are considering "hybrid" systems that have passive and active components for increased efficiency, especially where space limitations render passive-only technology ineffective. Flow-through reactor field experiments were conducted at two large net-alkaline anthracite mine discharges in central Pennsylvania. Assuming an Fe removal rate of 20 g m(-2) day(-1) and Fe loading from field data, 3.6 x 10(3) and 3.0 x 10(4) m(2) oxidation ponds would be required for the passive treatment of Site 21 and Packer 5 discharges, respectively. However, only a small area is available at each site. This paper demonstrates aeration to drive off CO2, increase pH, and increase Fe(II) oxidation rates, enabling treatment within a small area compared to passive treatment methods, and introduces a geochemical model to accurately predict these rates as well as semi-passive treatment system sizing parameters. Both net-alkaline discharges were suboxic with a pH of approximate to 5.7, Fe(II) concentration of approximate to 16 mg L-1, and low Mn and Al concentrations. Flow rates were approximate to 4000 L min(-1) at Site 21 and 15,000 L min(-1) at Packer 5. Three-h aeration experiments with flow rates scaled to a 14-L reactor resulted in pH increases from 5.7 to greater than 7, temperature increases from 12 to 22 degrees C, dissolved O-2 increases to saturation with respect to the atmosphere, and Fe(II) concentration decreases from 16 to <0.05 mg L-1. A 17,000-L pilot-scale reactor at Site 21 produced similar results although aeration was not as complete as in the smaller reactor. Two non-aerated experiments at Site 21 with 13 and 25-h run times resulted in pH changes of <= 0.2 and Fe(II) concentration decreases of less than 3 mg L-1. An Fe(II) oxidation model written in a differential equation solver matched the field experiments very well using field-measured pH, temperature, dissolved O-2, and initial Fe(II) concentration. The maximum oxidation rate was 1.3 x 10(-4) mol L-1 s(-1). The model was modified to predict alkalinity, P-CO2, dissolved O-2, and pH changes based on initial conditions and aeration rate. This more complex model also fits the data well, is more predictive than the first model, and should serve as a tool for predicting pond size needed for aerated Fe(II) oxidation at the field scale without the need for field pilot studies. Iron(II) oxidation modeling of actively aerated systems predicted that a 1-m deep pond with 10 times less area than estimated for passive treatment would lower Fe(II) concentrations to less than 1 mg L-1 at summer and winter temperatures for both sites. The use of active aeration for treatment Of CO2-rich, net-alkaline discharges (including partially treated effluent from anoxic limestone drains) can result in considerably reduced treatment area for oxidation and may lower treatment costs, but settling of Fe hydroxides was not considered in this study. The reduced capital cost for earthmoving will need to be compared to energy and maintenance costs for aeration.