...
首页> 外文期刊>Journal of Food Science and Technology >Effect of selected pretreatments prior to drying on physical quality attributes of dried mango chips
【24h】

Effect of selected pretreatments prior to drying on physical quality attributes of dried mango chips

机译:干燥干燥芒果芯片物质特征在干燥之前的效果

获取原文
获取原文并翻译 | 示例
           

摘要

This study investigated the effect of pretreatments namely citric acid, lemon juice and blanching on the physical attributes of dried chips from two popular commercial mango varieties grown in Kenya viz Apple' and Ngowe'. The pretreated mango chips were either subjected to a convective dryer or solar drying. Moisture content, extent of dryness, rehydration characteristics, water activity and color retention were determined to establish the effect of the pretreatments before drying on physical quality attributes of dried mango chips. Moisture content, water activity and color were determined using standard procedures. Equilibrium relative humidity was estimated using Drycard (TM). Results obtained indicated that optimal drying was achieved with dryer temperatures of 50 degrees C and 65 degrees C for 10 and 7h respectively that reduced moisture content to similar to 11% and water activity to below 0.65 (sufficient for inhibited spoilage). The best color parameters and rehydration characteristics were observed with 1% citric acid and 0.5v/v lemon acid pretreated samples. Blanched as well as control (untreated) samples showed relatively poor color retention in relation to flesh mango chips and had the least rehydration ratio (1.65 +/- 0.01) and coefficient of rehydration (0.33 +/- 0.1). As pretreatments before drying affect physical parameters of dried mango chips, the best choice of pretreatments should be made to produce high quality end products. Citric acid and lemon juice pretreatments before drying at 50 degrees C and 65 degrees C had the optimal outcome and produced the best physical quality parameters.
机译:本研究调查了预处理即柠檬酸,柠檬汁和漂白在肯尼亚·艾普·苹果'和Ngowe'中生长的两种流行商业芒果品种的干芯片物理属性的影响。预处理的芒果芯片经受对流干燥或太阳能干燥。确定水分含量,干燥程度,再水合特性,水活性和色素潴留,以确定在干燥干燥芒果芯片的物理质量属性之前对预处理的影响。使用标准程序确定水分含量,水活动和颜色。使用Drycard(TM)估计平衡相对湿度。得到的结果表明,使用50℃和65℃的干燥器温度分别将水分含量降低至类似于11%,水活性至0.65(足以抑制腐败的水)来实现最佳干燥。用1%柠檬酸和0.5V / V柠檬酸预处理样品观察到最佳颜色参数和再水化特性。 Blancanced以及对照(未处理)样品显示出与肉芒果芯片有关的颜色保留相对较差,并且具有最小的再水合比(1.65 +/- 0.01)和再水化系数(0.33 +/- 0.1)。作为干燥前的预处理影响干芒果芯片的物理参数,应制造最佳选择以生产高质量的最终产品。柠檬酸和柠檬汁在50℃和65℃下干燥前的预处理具有最佳结果,并产生了最佳的身体质量参数。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号