...
首页> 外文期刊>Nanotechnology >Mid-infrared non-volatile silicon photonic switches using nanoscale Ge2Sb2Te5 embedded in silicon-on-insulator waveguides
【24h】

Mid-infrared non-volatile silicon photonic switches using nanoscale Ge2Sb2Te5 embedded in silicon-on-insulator waveguides

机译:中红外非易失性硅光子开关,使用嵌入绝缘体硅的纳米级Ge2sb2te5

获取原文
获取原文并翻译 | 示例
           

摘要

We propose and numerically analyze hybrid Si-Ge2Sb2Te5 strip waveguide switches for the mid-infrared wavelength of 2.1 mu m. The switches investigated are of one input-one output (on-off) and one input-two outputs (directional coupler) types. The reversible transition between the switch states is achieved by inducing phase transition from crystalline to amorphous and vice-versa by application of voltage pulses. The approach of embedding the nanoscale active material Ge2Sb2Te5 within the Si waveguide is taken to enhance the interaction of light with the active region of the switches. The dimensions of the active regions of the switches are optimized to achieve low insertion loss, low switching energy and high extinction ratio. In the case of the on-off switch, an extinction ratio of 33.79 dB along with an extremely low insertion loss of 0.52 dB is achieved using an optimum Ge2Sb2Te5 length of only 0.92 mu m. For the directional coupler switch, an extinction ratio of 10.33 dB and 5.23 dB is obtained in the cross and bar states respectively using an active length of 52 mu m. These values of extinction ratio, which are otherwise 18.59 dB and 8.33 dB respectively, are due to the necessity of doping the Si beneath the Ge2Sb2Te5 to facilitate the electrical conduction needed for Joule heating. A suitable gap of 100 nm is maintained between the active and passive arm of the directional coupler switch. Electro-thermal co-simulations confirm that phase change occurs in the whole of the Ge2Sb2Te5 region in both types of switches.
机译:我们提出了用于中红外波长的2.1μm的混合Si-Ge2sb2te5条波导开关。研究的开关具有一个输入 - 一个输出(开关)和一个输入 - 两个输出(定向耦合器)类型。通过在施加电压脉冲通过诱导从结晶到无定形的相位过渡和反之亦然,实现开关状态之间的可逆转变。将嵌入纳米级活性材料GE2SB2TE5嵌入Si波导内的方法以增强光与开关的有源区的相互作用。开关的有源区的尺寸优化以实现低插入损耗,低开关能量和高消光比。在开关开关的情况下,使用仅0.92μm的最佳Ge2sb2te5长度,实现了33.79dB的消光比和0.52dB的极低插入损耗。对于定向耦合器开关,使用52μm的主动长度分别在十字架和条形中获得10.33dB和5.23dB的消光比。这些消光比值分别为18.59dB和8.33dB的消光比值是由于掺杂GE2SB2TE5下方的SI以便于焦耳加热所需的电传导。在定向耦合器开关的主动和无源臂之间保持100nm的合适间隙。电热共同模拟确认在两种类型的交换机中的整个GE2SB2Te5区域中发生相变。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号